EN75
4. To protect the unit, DO NOT . . .
How To Handle A CD-ROM
....allow it to become wet.
....drop the unit or strike it against hard objects.YTake care not to soil or scratch the mirror surface
....subject it to shock or excessive vibration(opposite to the printed surface). Do not write
during transportation.anything or put a sticker on either the front or
....keep the lens directed at extremely brightback surface. If the CD-ROM gets dirty, gently
objects for long periods.wipe it with a soft cloth outward from the centre
....expose the lens to direct sunlight.hole using a circular motion.
....carry it by holding the LCD monitor or theYDo not use conventional disc cleaners or cleaning
viewfinder.spray.
....swing it excessively when using the shoulder
YDo not bend the CD-ROM or touch its mirror
strap or the grip.surface.
5. Dirty heads can cause the following problems:YDo not store your CD-ROM in a dusty, hot or
humid environment. Keep it away from direct
sunlight.
About moisture condensation . . .
I You have observed that pouring a cold liquid
into a glass will cause drops of water to form
on the glass� outer surface. This same
YNo picture during playback.phenomenon occurs on the head drum of a
YBlocks of noise appear during playback.camcorder when it is moved from a cool
YDuring recording, the Head Clog Warningplace to a warm place, after heating a cold
indicator O � appears.room, under extremely humid conditions or
in a place directly subjected to the cool air
In such cases, use an optional cleaning cassette.
from an air conditioner.
Insert it and play back. If the cassette is used
I Moisture on the head drum can cause severe
more than once consecutively, damage to the
damage to the video tape, and can lead to
video heads may result. After the camcorder
internal damage to the camcorder itself.
plays back for about 20 seconds, it stops
automatically. Also refer to the cleaning cassetteOs
instructions.
If, after using the cleaning cassette, the problemsSerious malfunctioning
still exist, consult your nearest JVC dealer.
Mechanical moving parts used to move the videoIf malfunctioning occurs, stop using the unit
immediately and consult your local JVC dealer.
heads and video tape tend to become dirty and
worn out over time. In order to maintain a clear
picture at all times, periodic check-ups are
recommended after using the unit for about
The camcorder is a microcomputer-controlled
1,000 hours. For periodic check-ups please
device. External noise and interference (from a
consult your nearest JVC dealer.
TV, a radio, etc.) might prevent it from function-
ing properly. In such cases, first disconnect its
power supply unit (battery pack, AC Power
Adapter/Battery Charger, etc.) and wait a few
minutes and then re-connect it and proceed as
usual from the beginning. |
ACEC
