USER MAINTENANCE
54 EN
After UseCleaning The Camcorder
Turn off the camcorder.To clean the exterior, wipe gently with a soft
11cloth.
Put the cloth in diluted mild soap and wring it
Press PUSH OPEN and open the LCD monitor.well to wipe off heavy dirt. Then wipe again
2Slide OPEN/EJECT in the direction of the arrow,with a dry cloth.
then swing the cassette cover open until it locks.
The cassette holder opens automatically.Open the LCD monitor and wipe gently with a
Remove the cassette.2soft cloth. Be careful not to damage the
monitor. Close the LCD monitor.
Press OPUSH HERE� to close the cassette holder,
3then close the cassette cover.To clean the lens, blow it with a blower brush,
3then wipe gently with lens cleaning paper.
Close and lock the LCD monitor.
4To clean the viewfinder, raise it to the vertical
4position. Carefully lift the plastic tab on the
Slide BATTERY RELEASE and remove the batterybottom of the viewfinder, and open the cover
5pack.1.
Replace the lens cap over the lens.Insert a lens blower or soft cloth into the gap at
65the bottom of the viewfinder and clean the
interior of the viewfinder with it 2.
Replace the lens cap, making sure it locks in
6place. Tilt the viewfinder back to the horizontal
position.
OPEN/EJECT Switch
NOTES:
PUSH HERE
cAvoid using strong cleaning agents such as benzine
or alcohol.
PUSH OPEN Button
cCleaning should be done only after the battery
pack has been removed or other power units have
been disconnected.
cMould may form if the lens is left dirty.
cWhen using a cleaner or chemically treated cloth
refer to the cautions of each product.
Bottom of viewfinder
Remove.
Cassette holderBlower brush
2
BATTERY RELEASE Switch
1
Cover |
ACEC
