RECORDING Advanced Features For Video And D.S.C. (cont.)
26 EN
Fade/Wipe EffectsFADE/WIPE SELECTION (, , , ,
, , , , , and )
These effects let you make pro-style scene
transitions. Use them to spice up the transitionFade or Wipe works when video recording is started or
from one scene to the next. You can also varywhen you stop recording.
transitions from scene to scene.
Set the VIDEO/DSC Switch to OVIDEO�, then set the
IMPORTANT:1Power Switch to O � while pressing down the Lock
Some Fade/Wipe Effects cannot be used withButton located on the switch.
certain modes of Programme AE with special
effects ( pg. 28). If an unusable Fade/WipePress MENU/BRIGHT. The Menu Screen appears.
Effect is selected, its indicator blinks or goes2
out.
Rotate MENU/BRIGHT to select O�, then press it.
3
MENU/BRIGHT Wheel
Rotate MENU/BRIGHT to select the desired function,
4then press it. Selection is complete.
YThe FADER/WIPE Menu disappears and the effect is
reserved. The indicator representing the selected
effect appears.
Press the Recording Start/Stop Button to activate the
5Fade-in/out or Wipe-in/out.
RecordingPICTURE WIPE OR DISSOLVE SELECTION
Power Switch
Start/Stop Button(, , , , , and )
The Picture Wipe or Dissolve works when video recording
is started.
Follow steps 1 through 4 above.
1
If you select Picture Wipe/Dissolve during
2recording . . .
.... press the Recording Start/Stop Button when one
scene is finished. The point at which the scene
VIDEO/DSC Switch (Open theended is stored in memory.
LCD monitor to access this switch.)
If you select Picture Wipe/Dissolve during Record-
Standby mode . . .
.... press the Recording Start/Stop Button to start
To Deactivate The Selected Effect . . .
recording and press it again when one scene is
.... select OOFF� in step 4.
finished. The point at which the scene ended is
NOTES:stored in memory.
IYou can extend the length of a Fade or Wipe
If you select Picture Wipe/Dissolve during Record-
by pressing and holding the Recording Start/Standby mode after performing a Picture Wipe/
Stop Button.
Dissolve . . .
IIf the power is turned off after a scene is.... the point at which the scene ended is already
finished recording, the stored point is erased,
stored in memory.
disabling the Picture Wipe/Dissolve combina-
tion. When this happens, the Picture Wipe/If you start recording a new scene within 5 minutes of
Dissolve indicator blinks. Also note that3the end of the previous recording (without having
power shuts off automatically if 5 minutesturned the camcorderOs power off), the previous scene
elapse in the Record-Standby mode.wipes out, revealing the new scene.
IThe sound at the end of the last recorded
scene is not stored. |
ACEC
