EN59
Remote sensor
FEATURE:Slow-Motion Playback
PURPOSE:
To allow slow-speed search in either direction during
video playback.
OPERATION:
1) To change from normal to Slow-Motion Playback, press
SLOW (9 or 0) more than approx. 2 seconds. After
approx. 1 minute in Slow Rewind or approx. 2 minutes
in Slow Forward, normal playback resumes.
To stop Slow-Motion Playback, press PLAY (4).
NOTES:
IYou can also engage Slow-Motion Playback from Still
Playback by pressing SLOW more than approx. 2 seconds.
IDuring Slow-Motion Playback, due to digital image
processing, the picture may take on a mosaic effect.
IAfter SLOW (9 or 0) is pressed and held, the still image
SLOW Forwardmay be displayed for a few seconds, followed by a blue
Buttonscreen for a few seconds. This is not a malfunction.
SLOWIThere may be a small margin between the slow-motion
Rewind Buttonplayback start point you chose and the actual start
PLAYpoint for Slow-Motion Playback.
EFFECTIDuring Slow-Motion Playback, there will be distur-
PAUSE
ON/OFFbances in video and the picture may seem unstable,
especially with steady images. This is not a malfunction.
EFFECT
IDuring Slow-Motion Playback, press PAUSE (6) to
pause playback.
FEATURE:Frame-By-Frame Playback
PLAYBACKEFFECTPLAYBACKPURPOSE:
EFFECT Select
To allow frame-by-frame search during video playback.
OFFMenu
1CLASSICFILMOPERATION:
2MONOTONE
1) To change from normal to Frame-By-Frame Playback,
3SEPIA
4STROBEpress SLOW (0) repeatedly for forward or SLOW (9)
5VIDEOECHOrepeatedly for reverse. Each time it is pressed, the frame
is played back.
NOTE:
You can also engage Frame-By-Frame Playback from Still
Playback by pressing SLOW (9 or 0) repeatedly.
FEATURE: Playback Special Effects
PURPOSE:
To allow you to add creative effects to the video playback image.
OPERATION:
1) To start playback, press PLAY (4).
2) Point the remote control at the camcorder's remote sensor and press EFFECT. The PLAYBACK EFFECT Select
Menu appears.
3) Move the highlight bar to the desired effect by pressing EFFECT. The selected function is activated and after
2 seconds the menu disappears.
To deactivate the selected effect, press EFFECT ON/OFF on the remote control. Pressing it again re-activates the
selected effect.
To change the selected effect, repeat from step 2 above.
NOTES:
IWhen some Playback Special Effects are used, the Multi-Analyser 4 and Multi-Analyser 9 Snapshot modes
( pg. 42) are not available.
IThe effects that can be used during playback are Classic Film, Monotone, Sepia, Strobe and Video Echo. The
effects work the same in playback as they did in recording. Refer to page 39 for more information. |
ACEC
