FOR RECORDING (cont.)
40 EN
Fade/Wipe EffectsFADE/WIPE SELECTION (, , , ,
, , , , and )
These effects let you make pro-style scene
transitions. Use them to spice up the transitionFade or Wipe works when video recording is started or
from one scene to the next. You can also varywhen you stop recording.
transitions from scene to scene.
Set the VIDEO/DSC Switch to VIDEO
IMPORTANT:1(GR-DVL557/DVL555/DVL357/DVL355 only), then
Some Fade/Wipe Effects cannot be used withset the Power Switch to while pressing down
certain modes of Programme AE with specialthe Lock Button located on the switch.
effects ( pg. 38, 39). If an unusable Fade/
Wipe Effect is selected, its indicator blinks orPress the MENU/BRIGHT wheel in. The Menu
goes out.2Screen appears.
Rotate the MENU/BRIGHT wheel to select
MENU/BRIGHT Wheel3WIPE/FADER , then press it.
Rotate the MENU/BRIGHT wheel to select the
4desired function, then press it. Selection is complete.
Press the MENU/BRIGHT wheel in again.
Power Switch
"The WIPE/FADER Menu disappears and the effect is
reserved. The indicator representing the selected
effect appears.
Press the Recording Start/Stop Button to activate the
5Fade-in/out or Wipe-in/out.
Lock Button
Recording Start/Stop Button
To Deactivate The Selected Effect . . .
.... select OFF in step 4.
PICTURE WIPE OR DISSOLVE SELECTION
(, , , , , and )
The Picture Wipe or Dissolve works when video recording
is started.
Follow steps 1 through 4 above.
1
VIDEO/DSC Switch (GR-DVL557/
DVL555/DVL357/DVL355 only;If you select Picture Wipe/Dissolve during
open the LCD monitor to access
2recording . . .
this switch)
.... press the Recording Start/Stop Button when one
scene is finished. The point at which the scene
ended is stored in memory.
NOTES:If you select Picture Wipe/Dissolve during Record-
IYou can extend the length of a Fade or WipeStandby mode . . .
by pressing and holding the Recording Start/.... press the Recording Start/Stop Button to start
Stop Button.recording and press it again when one scene is
IIf the power is turned off after a scene isfinished. The point at which the scene ended is
finished recording, the stored point is erased,stored in memory.
disabling the Picture Wipe/Dissolve combina-If you select Picture Wipe/Dissolve during Record-
tion. When this happens, the Picture Wipe/
Standby mode after performing a Picture Wipe/
Dissolve indicator blinks. Also note thatDissolve . . .
power shuts off automatically if 5 minutes
.... the point at which the scene ended is already
elapse in the Record-Standby mode.stored in memory.
IThe sound at the end of the last recorded
scene is not stored.If you start recording a new scene within 5 minutes of
IPicture Wipe/Dissolve cannot be used while3the end of the previous recording (without having
Night-Scope is being activated ( pg. 38).turned the camcorders power off), the previous scene
wipes out, revealing the new scene. |
ACEC
