EN 73
SYMPTOMPOSSIBLE CAUSESCORRECTIVE ACTION
WThe LCD monitor, theY Wipe them gently with soft cloth.
viewfinder and the lensWiping strongly can cause damage
NNNN
have become dirty (ex. ( pg. 74).
fingerprints).
EAn unusual mark appears.Y Check the section of the manual
that explains LCD monitor/
NNNN
viewfinder indications
( pg. 82 � 86).
RAn error indicationY A malfunction of some kind hasY Remove the power supply (battery
(E01, E02 or E06) appears.occurred. In this case thepack, etc.) and wait a few minutes
camcorderOs functions becomefor the indication to clear. When it
unusable.does, you can resume using the
camcorder. If the indication
remains even though you repeat
the above two or three times,
please consult your nearest JVC
dealer. Do not eject the cassette.
This will cause damage to the tape.
TAn error indicationY A malfunction of some kind hasY Eject the cassette once and re-
(E03 or E04) appears.occurred. In this case theinsert it, then check if the indication
camcorderOs functions becomeclears. When it does, you can
unusable.resume using the camcorder. If the
indication remains even though
you repeat the above two or three
times, please consult your nearest
JVC dealer.
YThe charger indicator onY The temperature of the battery isY To protect the battery, it is
the camcorder does notextremely high/low.recommended to charge it in
light.Y Charging is difficult in placesplaces with a temperature of 10!C
subject to extremely high/lowto 35!C ( pg. 75).
temperatures.
UWhen the image is printedY This is not a malfunction.Y By recording with ODIS� activated
from the printer, a black bar( pg. 47) this can be avoided.
appears at the bottom of
the screen.
IWhen the camcorder isY The DV cable was plugged/Y Turn the camcorderOs power off
connected via the DVunplugged with power turned on.and on again, then operate it.
connector, the camcorder
does not operate.
OThe memory card cannotY Push in the memory card a few
be removed from theNNNNmore times ( pg. 14).
camcorder. |
ACEC
