12 ENGETTING STARTED (cont.)
Loading/Unloading A Cassette
Erase protection tab*
The camcorder needs to be powered up to load or
eject a cassette.
Make sure the
window side is1Slide and hold OPEN/EJECT in the direction of
facing out.the arrow then pull the cassette holder cover open
until it locks. The cassette holder opens automatically.
YDo not touch internal components.
Cassette holder
2Insert or remove a tape and press OPUSH HERE�
to close the cassette holder.
YOnce the cassette holder is closed, it recedes
automatically. Wait until it recedes completely before
closing the cassette holder cover.
YWhen the batteryOs charge is low, you may not be
able to close the cassette holder cover. Do not apply
force. Replace the battery with a fully charged one
OPEN/EJECTbefore continuing.
Switch
3Close the cassette holder cover firmly until it
Cassette holder cover
locks into place.
PUSH HERE
Approximate recording time
* To Protect Valuable Recordings . . .
Recording mode
....slide the erase protection tab on the back of the
Tape
tape in the direction of OSAVE �. This prevents theSPLP
tape from being recorded over. To record on this
30 min.30 min.45 min.
tape, slide the tab back to OREC � before loading it.
60 min.60 min.90 min.
Be sure to press only the section labeled OPUSH
HERE � to close the cassette holder; touching other80 min.80 min.120 min.
parts may cause your finger to get caught in the
cassette holder, resulting in injury or product damage.
NOTES:
I It takes a few seconds for the cassette holder to open. Do not apply force.
I If you wait a few seconds and the cassette holder does not open, close the cassette holder cover and try again. If the
cassette holder still does not open, turn the camcorder off then on again.
I If the tape does not load properly, open the cassette holder cover fully and remove the cassette. A few minutes later,
insert it again.
I When the camcorder is suddenly moved from a cold place to a warm environment, wait a short time before opening the
cassette holder cover.
I Closing the cassette holder cover before the cassette holder comes out may cause damage to the camcorder.
I Even when the camcorder is switched off, a cassette can be loaded or unloaded. After the cassette holder is closed
with the camcorder switched off, however, it may not recede. It is recommended to turn the power on before loading or
unloading.
I When resuming recording, once you open the cassette holder cover a blank portion will be recorded on the tape or a
previously recorded scene will be erased (recorded over) regardless of whether the cassette holder came out or not.
See page 20 for information about recording from the middle of a tape.
I Loosen the Grip Strap if it appears to interfere with the cassette holder cover operation ( pg. 10). |
ACEC
