EN11
Power Zoom LeverGrip Adjustment
Separate the Velcro strip.
1
Pass your right hand through the loop and grasp the
2grip.
Adjust so that your thumb and fingers can easily
3operate the Recording Start/Stop Button and the
Power Zoom Lever. Refasten the Velcro strip.
Recording
Start/Stop Button
Viewfinder Adjustment
Dioptre
GETTING STARTED
AdjustmentSet the Power Switch to O � or O �.
Control1The power lamp comes on and the camcorder is
turned on.
Slide the Dioptre Adjustment Control until the
2indications in the viewfinder are clearly focused.
Power Switch
Shoulder Strap Attachment
Following the illustration, thread the strap through the
1eyelet 1, then fold it back and thread it through the
3
buckle 2. Repeat the procedure to attach the other
1
4end of the strap to the other eyelet 3, making sure
the strap is not twisted.
2
Adjust as shown in the illustration 4.
2
Tripod Mounting
Align the screw and camera direction stud on the
1tripod with the cameraOs mounting socket and stud
hole. Then tighten the screw.
CAUTION:
When using a tripod, be sure to open and extend
its legs fully to stabilise the camcorder. To
prevent damage to the unit caused by falling
over, do not use a small-sized tripod. |
ACEC
