RECORDING Advanced Features (cont.)
26 EN
Fade/Wipe EffectsFADE/WIPE SELECTION (, , , ,
, , , , , and )
These effects let you make pro-style scene
transitions. Use them to spice up the transitionFade or Wipe works when recording is started or when
from one scene to the next. You can also varyyou stop recording.
transitions from scene to scene.
Set the Power Switch to O � while pressing down
IMPORTANT:1the Lock Button located on the switch.
Some Fade/Wipe Effects cannot be used with
certain modes of Program AE with specialPress the MENU/BRIGHT wheel. The Menu Screen
effects ( pg. 28). If an unusable Fade/Wipe2appears.
Effect is selected, its indicator blinks or goes
out.Rotate the MENU/BRIGHT wheel to select O�,
3then press it.
MENU/BRIGHT WheelRotate the MENU/BRIGHT wheel to select the
4desired function, then press it. Selection is complete.
YThe FADER/WIPE Menu disappears and the effect is
reserved. The indicator representing the selected
effect appears.
Press the Recording Start/Stop Button to activate the
5Fade-in/out or Wipe-in/out.
PICTURE WIPE OR DISSOLVE SELECTION
(, , , , , and )
RecordingThe Picture Wipe or Dissolve works when recording is
Power Switch
Start/Stop Buttonstarted.
Follow steps 1 through 4 above.
1
To Deactivate The Selected Effect . . .
.... select OOFF� in step 4.If you select Picture Wipe/Dissolve during
2recording . . .
NOTES:
.... press the Recording Start/Stop Button when one
IYou can extend the length of a Fade or Wipe
scene is finished. The point at which the scene
by pressing and holding the Recording Start/
ended is stored in memory.
Stop Button.
IIf the power is turned off after a scene isIf you select Picture Wipe/Dissolve during Record-
Standby mode . . .
finished recording, the stored point is erased,
disabling the Picture Wipe/Dissolve combina-.... press the Recording Start/Stop Button to start
recording and press it again when one scene is
tion. When this happens, the Picture Wipe/
Dissolve indicator blinks. Also note thatfinished. The point at which the scene ended is
stored in memory.
power shuts off automatically if 5 minutes
elapse in the Record-Standby mode.If you select Picture Wipe/Dissolve during Record-
IThe sound at the end of the last recordedStandby mode after performing a Picture Wipe/
scene is not stored.Dissolve . . .
.... the point at which the scene ended is already
stored in memory.
If you start recording a new scene within 5 minutes of
3the end of the previous recording (without having
turned the camcorderOs power off), the previous scene
wipes out, revealing the new scene. |
ACEC
