SYSTEM CONNECTIONSEN 65
[A] Using USB cable
To USBUSB cableTo USB
(provided)connector
PC
[B] Using DV cable
OR
Power Switch
Core filterCore filter
DV cable (optional)
To DVTo DV
IN/OUTconnector
PC with DV
connector
VIDEO/MEMORY Switch
(Open the LCD monitor to access this switch.)
NOTES:
Connection To A Personal Computer
I Refer to OSOFTWARE INSTALLATION AND USB
[A] Using USB cableCONNECTION GUIDE � for the installation of the
This camcorder can transfer still images to a PC bybundled software and drivers.
using the provided software.I It is recommended to use the AC Adapter as the
[B] Using DV cablepower supply instead of the battery pack ( pg. 9).
It is also possible to transfer still images to a PC withINever connect the USB cable and the DV cable
a DV connector by using software equipped with thesimultaneously to the camcorder. Connect only the
PC or commercially available software.cable you wish to use to the camcorder.
I If the PC connected to the camcorder via the USB
1Make sure the camcorder and PC are turned ofcable is not powered, the camcorder does not enter thef.
USB mode.
2Connect the camcorder to your PC using theI The date/time information cannot be captured into the
appropriate cable as shown in the illustration.PC.
I Refer to the instruction manuals of the PC and
3If you are using the USB connection, set the
Software.
VIDEO/MEMORY switch to OMEMORY �.
I The still images can also be transferred to a PC with a
YOnly the still images stored on the memory card canDV connector-equipped capture board.
be transferred to a PC.I When using a DV cable, be sure to use the optional
JVC VC-VDV206U or VC-VDV204U DV cable
4Turn the camcorderOs Power Switch to OPLAY�
depending on the type of DV connector (4 or 6 pins)
while pressing down the Lock Button located on the
on the PC, or use the DV cable provided with the
switch and turn on the PC.capture board.
YRefer to the instruction manual of the software onIThe system may not work properly depending on the
how to transfer a still image to the PC.PC or capture board you are using.
5When finished, turn off the PC first, then the
camcorder.
OACCESSING FILES� appears on the LCD monitor
while the PC is accessing data in the camcorder or
the camcorder is transferring a file to the PC.
NEVER disconnect the USB cable while OAC-
CESSING FILES� is displayed on the LCD monitor
since this can result in product damage. |
ACEC
