GETTING STARTED (cont.)
12 EN
Erase protection tab*Loading/Unloading A Cassette
The camcorder needs to be powered up to load or eject a
cassette.
Make sure theSlide and hold OPEN/EJECT in the direction of the
window side is1arrow then pull the cassette holder cover open until it
facing out.
locks. The cassette holder opens automatically.
YDo not touch internal components.
PUSH HERECassette
holder
Insert or remove a tape and press OPUSH HERE� to
2close the cassette holder.
YOnce the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette holder cover.
YWhen the batteryOs charge is low, you may not be
able to close the cassette holder cover. Do not
apply force. Replace the battery with a fully charged
one before continuing.
Cassette holder
cover
Close the cassette holder cover firmly until it locks
OPEN/EJECT Switch3into place.
*To Protect Valuable Recordings . . .Approximate recording time
....slide the erase protection tab on the back of
Recording mode
the tape in the direction of OSAVE�. This Tape
prevents the tape from being recorded over.SPLP
To record on this tape, slide the tab back to
30 min.30 min.45 min.
OREC� before loading it.
60 min.60 min.90 min.
Be sure to press only the section labeled OPUSH
HERE� to close the cassette holder; touching80 min.80 min.120 min.
other parts may cause your finger to get caught
in the cassette holder, resulting in injury or
product damage.
NOTES:
IIt takes a few seconds for the cassette holder to open. Do not apply force.
IIf you wait a few seconds and the cassette holder does not open, close the cassette holder cover and try
again. If the cassette holder still does not open, turn the camcorder off then on again.
IIf the tape does not load properly, open the cassette holder cover fully and remove the cassette. A few
minutes later, insert it again.
IWhen the camcorder is suddenly moved from a cold place to a warm environment, wait a short time before
opening the cassette holder cover.
IClosing the cassette holder cover before the cassette holder comes out may cause damage to the camcorder.
IEven when the camcorder is switched off, a cassette can be loaded or unloaded. After the cassette holder is
closed with the camcorder switched off, however, it may not recede. It is recommended to turn the power on
before loading or unloading.
IWhen resuming recording, once you open the cassette holder cover a blank portion will be recorded on the
tape or a previously recorded scene will be erased (recorded over) regardless of whether the cassette holder
came out or not. See page 20 for information about recording from the middle of a tape. |
ACEC
