RX-9010VBK
Removing the main board (See Fig.15)
I
JI
Prior to performing the following procedure, remove
the top cover, the rear panel and audio board.
J
1.Cut off the tie band fixing the harness.
CN811
J
2.Disconnect the harness from connector CN811 on
the power supply board respectively.
I
3.Disconnect the harness from connector CN881 on
the main board.
Main
board
NOTE:
CN813 CN881Tie band
In order to prevent the wire of CN881 from touching I
to the wire of CN813,the wire of CN881 is secured
by tape. This is one of the preventive measuresFig.15
for possible troubles of the remote controller.
When assembling the unit,secure the wire of CN881
with the original tape so as to prevent both wire from
touching each other.
4.Remove the four screws I and the two screws J
attaching the main board.
L
Heat sink
Removing the Amp board
(See Fig.16 to 17)
1.Remove the two screws L attaching the rear side of
main board from the heat sink .
L
2.Remove the ten screws K attaching each amp board
from the heat sink.
Main board
rear sideFig.16
Heat sink KKK
Fig.17
1-7 |
ACEC
