CAUTIONS (cont.)
94 EN
CassettesLCD Monitor
To properly use and store your cassettes, be sure to1. To prevent damage to the LCD monitor,
read the following cautions:DO NOT . . .
.... push it strongly or apply any shocks.
1. During use . . .
.... place the camcorder with the LCD monitor on
.... make sure the cassette bears the Mini DV mark.
the bottom.
.... be aware that recording onto prerecorded tapes
automatically erases the previously recorded2. To prolong service life . . .
video and audio signals..... avoid rubbing it with coarse cloth.
.... make sure the cassette is positioned properly3. Be aware of the following phenomena for LCD
when inserting.monitor use.
.... do not load and unload the cassetteThese are not malfunctions:
repeatedly without allowing the tape to run atYWhile using the camcorder, the surface around the
all. This slackens the tape and can result inLCD monitor and/or the back of the LCD monitor
damage.may heat up.
.... do not open the front tape cover. This exposesYIf you leave power on for a long time, the surface
the tape to fingerprints and dust.around the LCD monitor becomes hot.
2. Store cassettes . . .
.... away from heaters or other heat sources.
.... out of direct sunlight.Main Unit
.... where they wonOt be subject to unnecessary
1. For safety, DO NOT . . .
shock or vibration.
.... open the camcorderOs chassis.
.... where they wonOt be exposed to strong
.... disassemble or modify the unit.
magnetic fields (such as those generated by
.... short-circuit the terminals of the battery pack.
motors, transformers or magnets).
Keep it away from metallic objects when not in
.... vertically, in their original cases.
use.
.... allow inflammables, water or metallic objects to
enter the unit.
MultiMediaCards.... remove the battery pack or disconnect the
To properly use and store your MultiMediaCards, bepower supply while the power is on.
sure to read the following cautions:.... leave the battery pack attached when the
camcorder is not in use.
1. During use . . .
2. Avoid using the unit . . .
.... make sure the MultiMediaCard bears the
.... in places subject to excessive humidity or dust.
MultiMediaCard mark.
.... in places subject to soot or steam such as near a
.... make sure the MultiMediaCard is positioned
cooking stove.
properly when inserting.
.... in places subject to excessive shock or
2. While the MultiMediaCard is being accessedvibration.
(during recording, playback, deletion, initialisa-.... near a television set.
tion, etc.) . . ..... near appliances generating strong magnetic or
.... never unload the MultiMediaCard and neverelectric fields (speakers, broadcasting antennas,
turn off the camcorder.etc.).
3. Store MultiMediaCards . . ..... in places subject to extremely high (over 40!C)
.... away from heaters or other heat sources.or extremely low (under 0!C) temperatures.
.... out of direct sunlight.3. DO NOT leave the unit . . .
.... where they wonOt be subject to unnecessary.... in places of over 50!C.
shock or vibration..... in places where humidity is extremely low
.... where they wonOt be exposed to strong(below 35%) or extremely high (above 80%).
magnetic fields (such as those generated by.... in direct sunlight.
motors, transformers or magnets)..... in a closed car in summer.
.... near a heater. |
ACEC
