GETTING STARTED (cont.)
8 EN
Grip Adjustment
Separate the Velcro strip.
Power Zoom Lever
1
Pass your right hand through the loop and grasp
2the grip.
Recording Start/
Stop button
Adjust so that your thumb and fingers can easily
3operate the Recording Start/Stop Button and
Power Zoom Lever. Refasten the Velcro strip.
Viewfinder Adjustment
1Set the Power Switch to O � or O � while
1pressing down the Lock Button located on the
switch. Set the Shooting Mode Dial to any
position.
Power Switch
Pull out the viewfinder fully and adjust it
Dioptre Adjustment2manually for best viewability.
Control
Slide the Dioptre Adjustment Control until the
Shooting Mode Dial3indications in the viewfinder are clearly
focused.
Shoulder Strap Attachment
PAUSE
Following the illustration, thread the strap
1through the eyelet 1, then fold it back and
thread it through the buckle 2. Repeat the
procedure to attach the other end of the strap to
1the other eyelet 3, making sure the strap is not
twisted.
2
Tripod Mounting
3
Align the screw and camera direction stud on
1the tripod with the cameraOs mounting socket
and stud hole. Then tighten the screw.
YSome tripods are not equipped with studs.
CAUTION:
When using a tripod, be sure to open and
extend its legs fully to stabilise the
camcorder. To prevent damage to the unit
caused by falling over, do not use a small-
sized tripod. |
ACEC
