USING THE REMOTE CONTROL UNIT (cont.)
74 EN
ProgrammeSELECT SCENES
INOUTMODERandom AssemblePoint the remote control at the camcorderOs remote
1����:��~Editing Menu4sensor. Press PLAY (4) and then press R.A.EDIT ON/
2~
3~OFF on the remote control.
4~The Random Assemble Editing Menu appears.
5~
6~
7~If using a Fade/Wipe at the beginning of the scene,
8~5press FADE/WIPE on the remote control.
TC��:��YCycle through the effects by pressing repeatedly,
TOTAL00:00and stop when the one you want is displayed.
YYou cannot use a Picture Wipe/Dissolve at the
beginning of Programme 1.
Remote sensor
At the beginning of the scene, press EDIT IN/OUT on
6the remote control. The Edit-In position appears in
the Random Assemble Editing Menu.
At the end of the scene, press EDIT IN/OUT. The
7Edit-Out position appears in the Random Assemble
Editing Menu.
If using a Fade/Wipe at the end of the scene, press
8FADE/WIPE.
YCycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
YIf you select a Fade/Wipe effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
YYou cannot use a Picture Wipe/Dissolve at the end
of the last scene.
RM-V716UYWhen you use Fade/Wipe effects, that time is
(provided)included in the total time (this does not apply to
Picture Wipe/Dissolve).
1
PLAY
FADE/WIPE
If using Playback Special Effects, press EFFECT
EFFECT( pg. 71).
9
EDIT IN/OUTR.A.EDIT
ON/OFF
Repeat steps 6 through 9 to register additional scenes.
10YTo change previously registered points, press
CANCELCANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
YIf you are not using Fade/Wipe or Programme AE
with special effects, repeat steps 6 and 7 only.
NOTES:
IWhen choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between
them.
IIf the search time for an in-point exceeds 5 minutes, the recording deckOs Record-Standby mode will be
cancelled and editing will not take place.
IIf there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in
the edited version.
ISince time codes register time only as accurately as seconds, the time code total time may not match the
total programme time exactly.
ITurning off the camcorderOs power erases all registered Edit-In and Edit-Out points.
IIf you select Sepia or Monotone mode from Programme AE with special effects, you cannot use the Dissolve
or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next
Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during
recording, then use the Dissolve or Black & White Fader during Random Assemble Editing.
IIt is not possible to use Fade/Wipe effects and Programme AE with special effects during Random Assemble
Editing using a DV cable. |