TROUBLESHOOTING
EN 67
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC
dealer or Technical Service Center.
SYMPTOMPOSSIBLE CAUSESCORRECTIVE ACTION
1.No power is supplied.1.YThe power is not connected1.YConnect the AC Adapter
properly.securely (Z pg. 10).
YThe battery is dead.YReplace the dead battery
YThe LCD monitor is notwith a fully charged one
open fully when recording.(Z pg. 9).
YOpen the LCD monitor
fully. The LCD monitor
turns on/off when it is
opened/closed while the
Power Dial is set to OREC�.
2.Recording cannot be2.YThe tapeOs record safety tab2.YSet the tapeOs record safety
performed.is set to OSAVE�.tab to OREC� (Z pg. 13).
YThe Power Dial is set toYSet the Power Dial to
OPLAY�.OREC� (Z pg. 19).
YThe cassette's cover is open.YClose the cassette's cover.
3.There is no playback3.YThe camcorder is not getting3.YTurn the camcorderOs power
picture.power, or some otheroff and on again (Z pg. 19).
malfunction exists.
4.Some functions are not4.YThe shooting mode selector4.YSet the shooting mode
available.is set to OAUTO�.selector to "MANUAL"
YThe Power Dial is set to O5S�.(Z pg. 18).
YSet the Power Dial to any
position except O5S�
(Z pg. 28).
5.The focus does not adjust5.YFocus is set to OMANUAL�.5.YSet Focus to OAUTO�
automatically.YThe recording was done in a(Z pg. 46).
dark place, or the contrastYClean the lens and check
was low.the focus again (Z pg. 72).
YThe lens is dirty or covered
with condensation.
6.The cassette wonOt load6.YThe cassette is in the wrong6.YSet it in the right position
properly.position.(Z pg. 13).
YThe batteryOs charge is low.YInstall a fully charged
battery (Z pg. 8).
7.Play, Rewind and7.YThe Power Dial is not set to7.YSet the Power Dial to
Fast-Forward functionsOPLAY�.OPLAY� (Z pg. 49).
donOt work.YThe cassetteOs cover is open.YClose the cassette's cover
(Z pg. 13).
8.The tape is moving, but8.YThe LCD monitor is turned8.YPress and hold the IND/
thereOs no picture.off.DISPLAY button for over 2
YYour TV has AV inputseconds (Z pg. 23).
terminals, but is not set toYSet the TV to the mode or
its VIDEO mode.channel appropriate for
video playback (Z pg. 53).
9.In the 5-Second mode,9.YThe 5-Second mode in the9.YSelect O5S� or O5SD� in the
recording ends before 5System Menu is set toSystem Menu (Z pg. 33).
seconds have elapsed.OANIMATION�.
CONTINUED ON NEXT PAGE |
ACEC
