EN 61
Digital Dubbing
It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any image or sound deterioration.
To AC outlet
TW
PLAY
Connector is
under the cover.STOP
Lock!
Video unit equipped
with DV connector
To DVDV cable (optional)To DV
connectorconnector
CONFIRM POWER-OFF STATUSNOTES:
1Make sure the camcorderOs power is off.cYou cannot use the battery pack installed in the
camcorder as the power supply since a digital
MAKE CONNECTIONSsignal is output/input from/to the DV connector
2Attach the camcorder to the AC Chargeronly when using the AC Charger Station.
Station referring to step 2 as shown in thecIf the remote control is used when both the player
illustration on pg. 55.and recorder are JVC video units, both units will
Connect the camcorder to your video unitperform the same operation. To prevent this from
equipped with a DV connector using the DVhappening, press the buttons on both units.
cable (optional) as shown in the illustration.cFor Digital Dubbing, this camcorder can be
connected only to one device at a time. This
START PLAYBACK
camcorder can also be used as a recorder.
3Press the Play button (4) to play back thecIf a blank portion is played back during dubbing,
source tape.an unusual image may be dubbed.
cEven though the DV cable is connected correctly,
START RECORDING
sometimes the image may not appear in step 3. If
4While watching the playback on the monitor,
the above occurs, turn off power and make
engage the DV connector-equipped video
connections again.
unitOs record mode from the spot on the source1
cThe image with Digital Zoom, Fade/Wipe Effects,
tape you want to begin recording.
P.AE/Effects and Snapshot is not output from the
DV connector. Only the original playback image
is output from it.
To use this camcorder as a recorder . . .
1. Select the recording mode (Z pg. 13).
2. Turn the Power Dial to OPLAY� while pressing down the lock button located on it.
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press the START/STOP button to engage the Record-Pause mode. ODV IN� appears on the screen.
5. Press the START/STOP button to start recording. ODV IN� changes to ODV IN�.
6. Press the START/STOP button again to engage the Record-Pause mode. ODV IN� returns to ODV IN�. |
ACEC
