EN 13
Date/Time Settings
Date and time will automatically be recorded on tape at all times. It is your choice to display it or not during
playback (Z pg. 55).
LCD monitor
Lock button
REC MODESP
WIDE MODEOFF
ZOOM40XPower lamp
DISON
GAIN UPAGC
4TO DATE / TIME MENU5S
TO SYSTEM MENU
M
AYALP
OFF
END
Recording MenuPower Dial
ON SCREENOFFSelect Dial
DISPLAYONMENU button
4DATE / TIMEDEC 25 O 98
PM 5 : 30
RETURN
Date/Time Menu
Regarding Built-in Rechargeable Battery
SELECT OPERATION MODE
1Set the Power Dial to OM � while pressing downTo store the date/time in memory, a rechargeable
the lock button located on the dial, and openclock lithium battery is integrated in the camcorder.
the LCD monitor fully.While the camcorder is connected to an AC outlet
using the AC Charger Station, or while the battery
YThe power lamp comes on and thepack installed in the camcorder continues to supply
camcorder is turned on.power to the camcorder, the clock lithium battery is
YThe LCD monitor can be tilted upward up toalways charged. However, if the camcorder is not
180 degrees and downward up to 90 degrees.used for approx. 3 months, the clock lithium battery
will become discharged and the date/time stored in
ACCESS RECORDING MENUmemory will be lost. When this occurs, first connect
2Press MENU. The Recording Menu appears.the camcorder to an AC outlet using the AC Charger
Station etc. for over 24 hours to charge the clock
ACCESS DATE/TIME MENUlithium battery. Then perform the date/time setting
3Move the pointer and highlight bar to OTO
before using the camcorder.
DATE/TIME MENU� by rotating the Select Dial.
It is also possible to use the camcorder without the
Press the Select Dial and the Date/Time Menu
date/time setting.
appears.
INPUT DATE AND TIME
NOTE:
4Move the pointer and highlight bar to ODATE/
If you donOt exit the Date/Time Menu, the clock
TIME� by rotating the Select Dial. Press the
Select Dial and Omonth� is highlighted anddisplay will not move but the camcorderOs internal
clock continues to operate. Once you close the
begins blinking.
menu, the date and time begin operation from the
Rotating the Select Dial, input the month. Press
current date and time, with no delay or loss.
the Select Dial. Repeat the procedure to input
the day, year, hour and minute.
YPress the Select Dial twice when the pointer
and highlight bar are set to ORETURN� to exit. |
ACEC
