Master Page: Right
GR-DVP9Asia.book Page 37 Monday, February 10, 2003 1:12 PM
EN 37
Wide mode
System Menu
WIDE MODE(Factory-preset: OFF)
OFF: Records with no change in the screen ratio.
SYSTEM
For playback on a TV with a normal screen ratio.
CINEMA* : Inserts black bands at the top and
bottom of the screen. The indicator appears.
Beep, melody and shutter sound
During playback on wide-screen TVs, the black
bands at the top and bottom of the screen are cut BEEP(Factory-preset: MELODY)
and the screen ratio becomes 16:9. When using OFF: Even though not heard while shooting,
this mode, refer to your wide-screen TV?s shutter sound is recorded on the tape.
instruction manual. During playback/recording on BEEP: The beep sounds when the power is turned
4:3 TVs/LCD monitor/viewfinder, black bands are
on or off, and at the beginning and end of
inserted at the top and bottom of the screen and
recording. It also activates the shutter sound
the image appears like a letter boxed 16:9 movie.effect. ( pg. 23, 41)
SQUEEZE* : For playback on TVs with an
MELODY: Instead of a beep, a melody sounds
aspect ratio of 16:9. Naturally expands the image
when any operation is performed. It also activates
to fit the screen without distortion. The the shutter sound effect. ( pg. 23, 41)
indicator appears. When using this mode, refer to
your wide-screen TV?s instruction manual. During
playback/recording on 4:3 TVs/LCD monitor/Tally lamp setting
viewfinder, the image is elongated vertically.TALLY(Factory-preset: ON)
D.WIDE* : The indicator appears. The OFF: The tally lamp remains off at all times.
zoom range is extended beyond the maximum
ON: The tally lamp comes on to signal the start of
optical zoom wide angle range. This mode?s wide
angle setting is equivalent to using a 0.7X wide recording.
conversion lens. Zooming is possible from 0.7X to
a magnification set in CAMERA Menu. This mode Remote control setting
is suitable for shooting in a small room.
For details, refer to ?USING THE REMOTE
* Available only when the VIDEO/MEMORY CONTROL UNIT? ( pg. 54).
Switch is set to ?VIDEO?.REMOTE (Factory-preset: ON)
OFF: Disables the remote control operations.
Wind cut
ON: Enables the remote control operations.
ADVANCED FEATURES
WIND CUT(Factory-preset: OFF)
OFF: Disengages the function.Automatic demonstration mode
ON : Helps cut down on noise created by Demonstrates certain functions such as Program AE
wind. The ?? indicator appears. The quality of
with special effects, etc., and can be used to confirm
the sound will change. This is normal.how these functions operate. ( pg. 9)
DEMO MODE(Factory-preset: ON)
OFF: Automatic demonstration will not take
place.
ON: Demonstrates certain functions such as
Program AE with special effects, etc., and can be
used to confirm how these functions operate.
Demonstration starts in the following cases:
When the Menu Screen is closed after ?DEMO
MODE? is turned ?ON?.
With ?DEMO MODE? set to ?ON?, if there is no
operation for about 3 minutes after the Power
Switch is set to ?A? or ?M?.
Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will
resume.
CONTINUED ON NEXT PAGE |
ACEC
