FOR RECORDING (cont.)
48 EN
Fade/Wipe EffectsFADE/WIPE SELECTION (, , , ,
, , , , and )
These effects let you make pro-style sceneFade or Wipe works when video recording is started or
transitions. Use them to spice up the transition
from one scene to the next. You can also varywhen you stop recording.
transitions from scene to scene.Set the VIDEO/DSC Switch to OVIDEO� (GR-DVX78
IMPORTANT:1only), then set the Power Switch to O � while
Some Fade/Wipe Effects cannot be used withpressing down the Lock Button located on the
certain modes of Program AE with specialswitch. Open the LCD monitor fully or pull out the
effects ( pg. 46, 47). If an unusable Fade/viewfinder fully.
Wipe Effect is selected, its indicator blinks or
goes out.Press the MENU Wheel in. The Menu Screen
2appears.
VIDEO/DSC SwitchRotate the MENU Wheel to select O WIPE/
(GR-DVX78 only)3FADER�, then press it.
Rotate the MENU Wheel to select the desired
4function, then press it. Selection is complete. Press
Lock Buttonthe MENU Wheel in again.
YThe WIPE/FADER Menu disappears and the effect
is reserved. The indicator representing the selected
PLAYOFFeffect appears.
Press the Recording Start/Stop Button to activate the
Recording5Fade-in/out or Wipe-in/out.
Start/Stop
ButtonTo Deactivate The Selected Effect . . .
...select OOFF� in step 4.
Power Switch
PICTURE WIPE OR DISSOLVE SELECTION
(, , , , , and )
MENU WheelThe Picture Wipe or Dissolve works when video
recording is started.
Follow steps 1 through 4 above.
1
Engage the Record-Standby mode.
2If you select Picture Wipe/Dissolve during recording . . .
.... press the Recording Start/Stop Button when one
scene is finished. The point at which the scene
ended is stored in memory.
NOTES:If you select Picture Wipe/Dissolve during Record-
Standby mode . . .IYou can extend the length of a Fade or Wipe
by pressing and holding the Recording Start/.... press the Recording Start/Stop Button to start
recording and press it again when one scene isStop Button.
IIf the power is turned off after a scene isfinished. The point at which the scene ended is
stored in memory.
finished recording, the stored point is
erased, disabling the Picture Wipe/DissolveIf you select Picture Wipe/Dissolve during Record-
combination. When this happens, theStandby mode after performing a Picture Wipe/
Picture Wipe/Dissolve indicator blinks. AlsoDissolve . . .
note that power shuts off automatically if 5.... the point at which the scene ended is already
minutes elapse in the Record-Standby mode.stored in memory.
IThe sound at the end of the last recorded
scene is not stored.If you start recording a new scene within 5 minutes of
IPicture Wipe/Dissolve cannot be used while3the end of the previous recording (without having
Night-Scope is being activated ( pg. 45).turned the camcorderOs power off), the previous scene
wipes out, revealing the new scene. |
ACEC
