INDEX Docking Station
74 EN
1JLIP (Joint Level Interface Protocol) Connector
4 5 6
Connect to a JLIP-compatible camcorder or VCR
to control it from the computer using the provided
Software.
NOTE:
Make sure that the camcorder is turned on while
connecting the camcorder to a PC using the
1
Docking StationOs JLIP connector. If the camcorder
is turned off (because the Power Switch is set to
2OOFF� or due to Auto Shut Off* etc.) while the
JLIP programme software is used, it will be
3impossible to control the connected devices from
the computer. In such a case, first try turning the
camcorder on again, or unplug the JLIP connec-
tion cable from the Docking StationOs JLIP
connector. Then, initialize or run the software
again.
* Auto Shut Off:
If 5 minutes elapse in the Record-Standby mode
or in the Pause mode, the camcorderOs power
shuts off automatically to conserve energy.
7
2PC Connector [DIGITAL STILL]...........Z pg. 48
83Edit Connector [EDIT].........................Z pg. 57
Connect the editing cable when performing
9Random Assemble Editing (Z pg. 56 � 61).
4Stud....................................................Z pg. 46
0
5Screw.................................................Z pg. 46
6Multi Connector
The Docking Station can be connected with this
camcorder through this connector. Never touch it
with your hand or hit it with a hard object; if the
pins are damaged, the connectors will become
unusable due to contact failure.
7S-Video Output Connector
[S OUT] .......................................Z pg. 46, 57
8Video Output Connector
[VIDEO] .......................................Z pg. 46, 57
9 Audio Output Connector
[AUDIO L/R] ................................Z pg. 46, 57
0External Stereo Microphone Input
!Connector [MIC].................................Z pg. 62
!Screw Knob........................................Z pg. 46
To attach the camcorder, tighten this clockwise. |
ACEC
