RECORDING Advanced Features For Video And D.S.C. (cont.)
34 EN
Fade/Wipe EffectsFADE/WIPE SELECTION (, , , ,
, , , , and )
These effects let you make pro-style scene
transitions. Use them to spice up the transitionFade or Wipe works when video recording is started or
from one scene to the next. You can also varywhen you stop recording.
transitions from scene to scene.
Set the POWER Switch to while pressing
IMPORTANT:1down the Lock Button located on the switch and the
Some Fade/Wipe Effects cannot be used withMODE Dial to VIDEO or , then set the
certain modes of Programme AE with specialOperation Switch to . Pull out the viewfinder
effects ( pg. 36). If an unusable Fade/Wipefully or open the LCD monitor fully.
Effect is selected, its indicator blinks or goes
out.Press the MENU wheel. The Menu Screen appears.
2
START/STOP ButtonRotate the MENU wheel to select , then press it.
3
MODE Dial
Rotate the MENU wheel to select the desired
POWER Switch
4function, then press it. Selection is complete.
YThe FADER/WIPE Menu disappears and the effect is
reserved. The indicator representing the selected
effect appears.
Lock Button
Press START/STOP to activate the Fade-in/out or
5Wipe-in/out.
Operation Switch
PICTURE WIPE OR DISSOLVE SELECTION
(, , , , , and )
The Picture Wipe or Dissolve works when video recording
is started.
MENU WheelFollow steps 1 through 4 above.
1
Engage the Record-Standby mode.
To Deactivate The Selected Effect . . .2
If you select Picture Wipe/Dissolve during
.... select OFF in step 4.
recording . . .
.... press START/STOP when one scene is finished.
NOTES:
The point at which the scene ended is stored inIYou can extend the length of a Fade or Wipe
memory.
by pressing and holding START/STOP.
IIf the power is turned off after a scene isIf you select Picture Wipe/Dissolve during Record-
finished recording, the stored point is erased,Standby mode . . .
disabling the Picture Wipe/Dissolve combina-.... press START/STOP to start recording and press it
tion. When this happens, the Picture Wipe/again when one scene is finished. The point at
Dissolve indicator blinks. Also note thatwhich the scene ended is stored in memory.
power shuts off automatically if 5 minutes
If you select Picture Wipe/Dissolve during Record-
elapse in the Record-Standby mode.
Standby mode after performing a Picture Wipe/
IPicture Wipe/Dissolve cannot be used when
Dissolve . . .
the MODE Dial is set to .
.... the point at which the scene ended is already
IAll Fade/Wipe Effects cannot be used when
stored in memory.
the MODE Dial is set to DUAL .
IThe sound at the end of the last recordedIf you start recording a new scene within 5 minutes of
scene is not stored.3the end of the previous recording (without having
turned the camcorderOs power off), the previous scene
wipes out, revealing the new scene. |
ACEC
