CAUTIONS (cont.)
94 EN
CassettesLCD Monitor
To properly use and store your cassettes, be sure to1. To prevent damage to the LCD monitor,
read the following cautions:DO NOT . . .
.... push it strongly or apply any shocks.
1. During use . . .
.... place the camcorder with the LCD monitor on
.... make sure the cassette bears the Mini DV mark.
the bottom.
.... be aware that recording onto prerecorded
tapes automatically erases the previously2. To prolong service life . . .
recorded video and audio signals..... avoid rubbing it with coarse cloth.
.... make sure the cassette is positioned properly3. Be aware of the following phenomena for LCD
when inserting.monitor use.
.... do not load and unload the cassetteThese are not malfunctions:
repeatedly without allowing the tape to run at all.YWhile using the camcorder, the surface around
This slackens the tape and can result in damage.the LCD monitor and/or the back of the LCD
.... do not open the front tape cover. This exposesmonitor may heat up.
the tape to fingerprints and dust.YIf you leave power on for a long time, the
2. Store cassettes . . .surface around the LCD monitor becomes hot.
.... away from heaters or other heat sources.
.... out of direct sunlight.
Main Unit
.... where they wonOt be subject to unnecessary
shock or vibration.1. For safety, DO NOT . . .
.... where they wonOt be exposed to strong.... open the camcorderOs chassis.
magnetic fields (such as those generated by.... disassemble or modify the unit.
motors, transformers or magnets)..... short-circuit the terminals of the battery pack.
.... vertically, in their original cases.Keep it away from metallic objects when not in
use.
.... allow inflammables, water or metallic objects
MultiMediaCardsto enter the unit.
.... remove the battery pack or disconnect the
To properly use and store your MultiMediaCards, be
power supply while the power is on.
sure to read the following cautions:
.... leave the battery pack attached when the
1. During use . . .camcorder is not in use.
.... make sure the MultiMediaCard bears the
2. Avoid using the unit . . .
MultiMediaCard mark.
.... in places subject to excessive humidity or dust.
.... make sure the MultiMediaCard is positioned
.... in places subject to soot or steam such as near
properly when inserting.
a cooking stove.
2. While the MultiMediaCard is being accessed (during
.... in places subject to excessive shock or vibration.
recording, playback, deletion, initialisation, etc.) . . .
.... near a television set.
.... never unload the MultiMediaCard and never
.... near appliances generating strong magnetic or
turn off the camcorder.
electric fields (speakers, broadcasting antennas,
3. Store MultiMediaCards . . .etc.).
.... away from heaters or other heat sources..... in places subject to extremely high (over 40!C)
.... out of direct sunlight.or extremely low (under 0!C) temperatures.
.... where they wonOt be subject to unnecessary
3. DO NOT leave the unit . . .
shock or vibration.
.... in places of over 50!C.
.... where they wonOt be exposed to strong
.... in places where humidity is extremely low
magnetic fields (such as those generated by
(below 35%) or extremely high (above 80%).
motors, transformers or magnets).
.... in direct sunlight.
.... in a closed car in summer.
.... near a heater. |
ACEC
