EN7
Charge Marker
Charge markerA charge marker is provided on the battery pack to
help you remember whether it has been charged or
not. Two colours are provided (red and black)Nyou
choose which one means charged and which means
discharged.
NOTES:
cThe recording time per charge is affected by such factors as the time spent in Record-Standby mode and the
frequency of zooming. It is safer to have spare battery packs to cover 3 times the planned shooting time.
cCharging times noted on page 6 are for a fully discharged battery pack, and discharging times are for a fully
charged battery pack.
cCharging and discharging times vary according to the ambient temperature and the status of the battery pack.
cRemember to set the charge marker after charging a battery pack or after detaching a discharged one from
your camcorder.
cPerform the REFRESH function after no less than 5 chargings.
cWhile the AC Power Adapter/ChargerOs power cord is disconnected from the AC outlet, it is possible to
discharge the battery by pressing the REFRESH switch. During that time, the AC Power Adapter/Charger does
not charge the battery. When discharging is complete, detach the battery from the AC Power Adapter/
Charger to store it.
cHigh temperatures can damage the battery pack, so use only where good ventilation is available. Do not
allow it to discharge in a container, such as a bag.
cIf you stop recharging or discharging part way through, make sure to remove the battery pack before
unplugging the adapterOs AC cord.
cRemove the battery pack from the adapter immediately after discharging.
cTo avoid interference with reception, do not use the AC Power Adapter/Charger near a radio.
cMake sure you unplug the DC cord before charging or discharging the battery pack.
cThe CHARGE indicator may not light properly with a brand new battery pack, or with one that has been
stored for an extended period. In this case, remove and reattach the battery pack and recharge it. The
CHARGE indicator should blink during recharging. If not, contact your nearest JVC dealer.
USING AC POWER
To DC IN jackTo AC outlet
Use the AC Power Adapter/Charger (connect as
shown in the illustration).
DC OUTNOTES:
terminal
cThe provided AC Power Adapter/Charger features
automatic voltage selection in the AC range from
110 V to 240 V.
cWhen using the DC cord, make sure you connect
DC Cordthe end of the cord with the core filter to theAC Power
Adapter/Charger
camcorder. The core filter reduces interference.
AA-V15EA
USING A CAR BATTERY
To carOsUse the optional Car Battery Charger/Adapter
cigarette
(connect as shown in the illustration).
lighter
socket
NOTES:
cWhen using the car battery, leave the engine
idling.
cThe optional Car Battery Charger/Adapter (BH-V3E)
can also be used to charge the battery pack (except
Car BatteryBN-V20U/V856U).
Charger/AdaptercWhen using the optional Car Battery Charger/
BH-V3E (optional)
Adapter, refer to the respective instruction booklet. |
ACEC
