USING THE REMOTE CONTROL UNIT (cont.)
48 EN
Insert Editing
Power Switch
You can record a new scene onto a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V700U remote control unit to perform this
procedure.
SELECT OPERATION MODE
1Set the Power Switch to OPLAY�.
FIND EDIT-OUT POINT
2Play back the tape, locate the point and press PAUSE
REW (2) Buttonon the camcorder or the remote control.
FF (3) Button
RESET COUNTER
PLAY/PAUSE (4/6) Button3Press and hold COUNTER R/M for more than
1 second to reset the tape counter, then press again
STOP (5) Buttonfor less than 1 second so that OM� appears.
COUNTER R/M ButtonFIND EDIT-IN POINT
4Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
Display
recorded tape, and press PAUSE exactly at the
wpoint where the new scene should start.
Insert editing
indicatorENGAGE INSERT EDITING MODE
M 0 : 12 : 34Tape Counter5Press and hold INSERT, and without releasing
INSERT, press and release PAUSE. The Insert Editing
mode is engaged. When the scene the camcorder is
aimed at appears on the screen, go to the next step.
BEGIN INSERT EDITING
Remote sensor6Press START/STOP. When the counter reaches
O0:00:00�, editing stops automatically and the
camcorder enters the Insert-Pause mode.
END INSERT EDITING
7Press STOP.
NOTES:
cDuring Insert Editing, the original audio will be heard
from the speaker.
cAfter step 5, Retake (Z pg. 17) can be performed.
cThe tape may stop slightly before or after the designated
end point, and noise bars may appear. Neither indicates
a defect in the unit.
START/STOP
PAUSEcOnly the video signal is recorded in the Insert Editing
mode.
STOP
REW
PLAYINSERT
RM-V700U
(provided) |
ACEC
