Master Page: Left
GR-PD1PAL.book Page 58 Tuesday, June 17, 2003 7:31 PM
58 ENUSING THE REMOTE CONTROL UNIT (cont.)
Playback Special Effects (DV only)
Audio Dubbing (DV only)
Allows you to add creative effects to the video
playback image that was recorded in DV mode.The audio track of a tape recorded in DV format can
The effects that can be used during playback are be customized only when recorded in the 12-bit and
CLASSIC FILM, MONOTONE, SEPIA and STROBE. SP modes. ( pg. 34)
The effects work the same in playback as they did in
Stereo Microphone
recording. ( pg. 48)
CLASSIC FILM: Gives recorded scenes a Headphone Connector
strobe effect. Using this effect with ?DV WIDE? set
to ?SQUEEZE? ( pg. 36) provides ?classic film?
effect.
MONOTONE: Like classic black and white
films, your footage is shot in B/W. Used together A.DUB
PLAY
with the Cinema mode, it enhances the ?classic
PAUSE
film? effect. Using this effect with ?DV WIDE? set to
?SQUEEZE? ( pg. 36) provides ?classic film? STOP
effect.Speaker
SEPIA: Recorded scenes have a brownish tint
like old photos. Combine this with the Cinema 1Play back the tape to locate the point where
mode for a classic look.editing will start, then press PAUSE (9).
STROBE: Your recording looks like a series of 2While holding A. DUB (D) on the remote
consecutive snapshots.control, press PAUSE (9). The ?9D? and ?MIC?
1) To start playback, press PLAY (U).indicators appear.
2) Press EFFECT. The PLAYBACK EFFECT Select 3Press PLAY (U), then begin ?narrating?. Speak
Menu appears.into the microphone.
3) Press EFFECT repeatedly to move the highlight I To pause dubbing, press PAUSE (9).
bar to the desired effect.
4To end Audio Dubbing, press PAUSE (9), then
I The selected function is activated and after
2 seconds the menu disappears.STOP (8).
I To deactivate the selected effect, press EFFECT To hear the sound during Audio Dubbing...
ON/OFF. To reactivate the selected effect press Connect optional headphones to the headphone
EFFECT ON/OFF again.connector or use the S/AV connector, and set ?DV
I To change the selected effect, repeat from NARR.? to the desired mode;
step 2 above.?OFF? for the playback sound.
?ON? for the dubbed sound.
?MIX? for the playback and dubbed sound.
To hear the dubbed sound during playback?
Set ?DV NARR.? to ?ON? or ?MIX?. ( pg. 33, 39) |
ACEC
