Connections To A TV/VCRTape Dubbing
1) Make sure all units are turned off.1) Connect the camcorder and the VCR
2) Connect the camcorder to a TV or VCR using( OConnections To A TV/VCR�). Set the Power
optional video and audio cables. If using bothSwitch @ to OPLAY� while pressing down the
TV and VCR, connect the VCR output to the TVLock Button ! located on the switch, turn on
input.the VCROs power, and insert the appropriate
3) Turn on all units. Set the VCR to its AUX inputcassettes in the camcorder and the VCR.
mode, and set the TV to its VIDEO mode.Engage the VCROs AUX and Record-Pause
YUse the AC Adapter as the power supply.modes.
YBe sure to adjust the TV sound volume to its2) Press 4/6 & to find a spot just before the edit-
minimum level to avoid a sudden burst of soundin point. Once it is reached, press 4/6 & again.
when the camcorder is turned on.3) Press 4/6 & and engage the VCROs Record
YIf you have a TV or speakers that are notmode.
specially shielded, do not place the speakers4) Engage the VCROs Record-Pause mode and
adjacent to the TV as interference will occur in thepress 4/6 &.
camcorder playback picture.YRepeat steps 2) through 4) for additional editing,
YThe S-Video cable connection can improve thethen stop the VCR and camcorder when finished.
dubbed picture quality. The S-Video cable is
optional. Be sure to use the following cable:
YTU94146A S-Video cable.
Consult the JVC Service Center described on the
sheet included in the package for details on its
availability. Make sure to connect the end with a
core filter to the camcorder. The core filter
reduces interference.
White to
To S-VideoAudio
Output 5Output 6
Yellow to
Video
Output 7
Connector cover
S-VideoA/V cable
cable(optional)
(optional)
TV
To S-VideoWhite to
InputAudio Input
VCR
Yellow to
Video Input
15
GR-SXM260_12-16_EN1517/11/03, 2:56 PM |
ACEC
