TAPE LENGTHINT. TIME
Allows you to set the tape length depending on theYou can record sequentially at preset time spans.
tape used: T20=20 minutes, T30=30 minutes,Leaving the camcorder aimed at a specific subject,
T35=35 minutes, T40=40 minutes.you can record subtle changes over an extended
YTape remaining time W is correct only if theperiod of time (Time-Lapse). REC MODE should
correct tape length has been selected.be set to OSP�.
(Please note that it is necessary to set the REC
DISPLAY
FULL: Makes all of the indications appear on theTIME (Animation) in the SYSTEM MENU before
performing the INT. TIME (Time-Lapse) function.)
LCD monitor/viewfinder during playback orSelect the desired interval time and press the
recording.
SIMPLE: Makes the following indicationsRecording Start/Stop Button 0.
YFade- or wipe-in/out cannot be performed.
disappear from the LCD monitor/viewfinder duringYThis function is cancelled when the power is shut
recording or playback: , tape remaining time,
, tape length ( pg. 9, 17).off or when the cassette is ejected.
YTo use this function, it is recommended that
DATE/TIME DISP.SCROLL in TITLE SETUP ( pg. 18, 19) be set
Makes the date/time appear in the camcorder or onto OOFF�.
a connected monitor (set DATE/TIME in SYSTEMTELE MACRO
MENU first pg. 7).
YThe selected display will be recorded. If you doWhen set to OON�, you can shoot a subject as large
as possible at a distance of approx. 60 cm.
not want to record the display, select OFF beforeDepending on the zoom position, the lens may go
shooting.out of focus.
YIn the AUTO DATE mode, the camcorder records
the date for about 5 seconds when recording is
initiated after the date is changed, a cassette is
loaded, or AUTO DATE is selected. The date is
replaced after 5 seconds with OAUTO DATE� but
this is not recorded.
OSD OUTPUT
ON: On-screen indications are displayed.
OFF: On-screen indications are turned off except
Date/Time, Instant Title and Warning Indication.
REC TIME
You can shoot a series of pictures, each slightly
different, of the same object for a brief selected
period of time (Animation). REC MODE should be
set to OSP�.
Select the desired recording time and press the
Recording Start/Stop Button 0 after focusing on
the subject.
YFade- or wipe-in/out cannot be performed.
YThis function is cancelled when the power is shut
off or when the cassette is ejected.
YTo use this function, it is recommended that
SCROLL in TITLE SETUP ( pg. 18, 19) be set
to OOFF�.
21
GR-SXM260_17-22_EN2117/11/03, 2:59 PM |
ACEC
