UX-P7R
Removing the tuner board D
CN1
(See Fig.4 and 5)
Prior to performing the following procedure, remove board
the metal cover.
1.Disconnect the card wire from connector CN1 on the
tuner board.
2.Remove the screw D on the right side of the body.
3.Remove the two screws E on the rear panel.
Fig.4
E
Removing the CD mechanism assembly
(See Fig.6 to 8)
Prior to performing the following procedure, remove
the metal cover and the rear cover.
Rear cover
1.Disconnect the card wires from connector CN903,
CN904 and the wire from CN905 on the main board
Rear panel
on the upper side of the body.
2.Remove the screw D attaching the tuner board and
Fig.5
the CD mechanism on the right side of the body.
Rear panel
3.Remove the two screws F attaching the rear panel
and the CD mechanism on the back of the body.Main board
CN905
Tuner board
4.Move the rear part of the CD mechanism assembly
upwards to disengage the two joints a and release
from the rear panel.
CN904
Pull the front panel toward the front and move the
rear part of the CD mechanism assembly upwards. Card wires
Then pull out the CD mechanism assembly from the CN903
front panel backward.
REFERENCE: To remove the CD mechanism assembly Front panel assemblyCD mechanism assembly
efficiently, disconnect the card wire
Fig.6
connecting the tuner board with the main
board in advance.CD mechanism assembly
Tuner board
D
Fig.7
1-8 |
ACEC
