Connections To A TV/VCRTape Dubbing
1) Make sure all units are turned off.1) Connect the camcorder and the VCR
2) Connect the camcorder to a TV or VCR. If using( OConnections To A TV/VCR�). Set the Power
both TV and VCR, connect the VCR output toSwitch @ to O� while pressing down the
the TV input.Lock Button ! located on the switch, turn on the
3) Turn on all units. Set the VCR to its AUX inputVCROs power, and insert the appropriate
mode, and set the TV to its VIDEO mode.cassettes in the camcorder and the VCR.
YUse the AC Adapter as the power supply.Engage the VCROs AUX and Record-Pause
YBe sure to adjust the TV sound volume to itsmodes.
minimum level to avoid a sudden burst of sound2) Press 4/6 & to find a spot just before the edit-
when the camcorder is turned on.in point. Once it is reached, press 4/6 & again.
YIf you have a TV or speakers that are not3) Press 4/6 & and engage the VCROs Record
specially shielded, do not place the speakersmode.
adjacent to the TV as interference will occur in the4) Engage the VCROs Record-Pause mode and
camcorder playback picture.press 4/6 &.
YIf your TV/VCR has a 21-pin connector, use theYRepeat steps 2) through 4) for additional editing,
provided Cable Adapter.then stop the VCR and camcorder when finished.
YThe S-Video cable connection can improve the
dubbed picture quality. If your TV/VCR has a
21-pin connector, use a commercially available
cable adapter with an S-Video connector
(GR-SXM49/SX25 only).
White to
To S-VideoAudio
Output 5Output 6
Yellow to
Video
Output 7
Connector cover
S-VideoA/V cable
cable
TV
White to
To S-VideoAudio Input
Input
VCR
Yellow to
Video Input
15
01 GR-SXM49EG_EN (EX)1502.10.30, 15:06 |
ACEC
