EN53
NOTE:
Use the remote control unit to perform the following procedures.
Insert Editing (Insert A Still ImageAudio Dubbing
From The Built-in Memory Onto AYou can record a new soundtrack on a prerecorded
tape (normal audio only). The sound is recorded from
the built-in microphone.Tape)
You can insert a still image stored in the camcorderOsPerform steps 1, 2 and 3 of the Insert Editing
built-in memory into a previously recorded tape,(VIDEO) procedure ( pg. 52) before continuing.
replacing a section of the original recording with
minimal picture distortion at the in- and out-points.Press REW to go a little beyond the beginning of
The original audio remains unchanged.1the scene onto which you want to dub the new
Perform steps 1 through 5 in Insert Editing (VIDEO)audio, press PLAY to view the recorded tape,
( pg. 52) before the following procedure.then press PAUSE at exactly the point where
dubbing should start.
Press REFRESH for approx. 1 second to select
1ODSC�. The DSC Lamp comes on. Press REWPress and hold A. DUB, and without releasing
or FF to select the still image you wish to insert.2A. DUB, press and release PAUSE on the
Remote Control. The Audio Dub-Standby mode
To begin Insert Editing, press START/STOP.is engaged.
2When the counter reaches O0:00:00�, editing
stops automatically and the camcorder entersTo begin Audio Dubbing, press PLAY. When the
the Insert-Pause mode.3counter reaches O0:00:00�, Audio Dubbing
stops automatically and the camcorder entersTo insert still images in sequential order onto
the Audio Dub-Standby mode.
the tape . . .
... press REW or FF to move the page forward.
To end Audio Dubbing, press STOP.To insert still images at random onto the
4
tape . . .
... first record the still image you selected in
step 1 onto the tape, then press START/NOTES:
STOP to engage the Insert-Pause mode. ToIDo not press FF or REW during Audio Dub-
select another still image, press REW or FFStandby, or the edit points will not be accurate.
again, then press START/STOP. Insert EditingIIf the microphone is too close to the TV, or if the
begins.TVOs volume is too high, whistling or howling may
occur.
To end Insert Editing, press STOP.
NOTES
(for Insert Editing and Audio Dubbing):3
IInsert Editing and Audio Dubbing may not work
NOTES:correctly if the tape contains blank segments, or if
IThe tape may stop slightly before or after thethe recording speed was changed during the
designated end point, and noise bars may appear.original recording.
Neither indicates a defect in the unit.ITo edit/dub onto a tape, make sure the Erase
IOnly video signal is recorded in the Insert EditingProtection tab is in the position that allows
mode.recording. If not, slide the tab. Some cassettes have
removable tabs. If the tab has been removed, cover
the hole with adhesive tape.
IDo not press STOP during Insert Editing or Audio
Dubbing, or the edit points will not be accurate.
IDuring Insert Editing and Audio Dubbing, when
Insert-Pause or Audio Dub-Standby is engaged, the
counter may go slightly past O0:00:00�. Recording,
however, stops at exactly 0:00:00. |
ACEC
