EN 41
OTHER PROBLEMS:
This printer contains microprocessors. External electronic noise or interference could cause
malfunctioning. In such a case, switch the power off. Then turn on the power and check again.
IfCheck to see ifPage
No power is applied tocHas the battery been properly charged?
the printer.cHas the power supply been correctly connected?16
The error icon E is litcIs a message displayed on the LCD panel?
(or blinks) on the LCDIf a message is displayed, follow instructions on page 40.
panelIf not, turn off the printer and wait. Then turn on the40
power again.
Paper jamcA paper jam may be caused by the following factors.
á Paper was not inserted straight during manual feed.34
á The printer was placed on its side or on a leaning
surface.
cRemove a jammed paper according to instructions on42
page 42.
The video source imagecIs the video cable correctly connected?
you wish to print is notcIs the TV input selector set to OVideo (external input)�?14
displayed on the TV.cThe input terminal has priority.
The TV is showing a stillcIs the TV showing the stored image (memory image)?13
image.Set the Omonitor� menu to Oinput pic�.
The stored imagecThe stored image is deleted when the power is turned
disappeared.off. Store the image again.�
The color appearscThe color may differ somewhat from the image displayed
faded.on the TV. This is not due to any defect of the printer.�
The color differs from
set image
The image qualitycImage adjustment is not possible when the menu input�
cannot be adjustedmode is something other than video.
The printed image is notcThe printed image is not clean when dirt or dust adheres�
clean.to the printing paper. Dirt and dust can also cause
equipment breakdown.
Stripes on the printedcDue to the reflection of light, stripes may appear on the
surfaceprinted surface. This is normal and is not a cause for�
concern.
The printed image maycThe tint and brightness of the printed image may differ
differ from the TVfrom the image as it is displayed on the TV connected to�
image.the printer. This is normal and not a failure. |
ACEC
