�����������������������������������������5. Pattern mode
value of the parameter.
Editing motion sequence
3. Press a part key to select the part that you wish to edit.
data
4. Press a step key to select the step that you wish to edit. The
You can edit the motion sequence of each part or the effect motionsteps of a pattern whose length is two or greater can be selected
sequence. The data can be edited in units of individual steps.successively by pressing the SELECT key.
5. Rotate the dial to edit the parameter value at that step. If the
Selecting a motion sequence
display indicates OdiS,� the motion sequence does not apply to
that step.
MOTION DEST.
5
PCh (PITCH/SPEED)...tin (TIME)
1. Select the pattern that contains the motion sequence data you
wish to edit.
2. Use the cursor keys [2][1] to make the parameter select LED
indicate MOTION DEST.
1
3. Rotate the dial to select the parameter that you wish to edit.
For PCh (PITCH/SPEED), LEU (LEVEL), FLt (FILTER), and PAn
3
(PAN), only one parameter is valid for each part.
EFF (EFFECT), roL (ROLL), and rEU (REVERSE) are valid for each
4
part.
Ed1 (EDIT 1), Ed2 (EDIT 2), dPt (DEPTH), and tin (TIME) are valid
for the pattern (all parts).
For PITCH, FIL TER, LEVEL, and PAN motion sequences,
1,3using MOTION DEST . to change the parameter and editing
will cause all values to be initialized to ? diS.?
If you move to another pattern without writing the edited mo-
tion sequence, it will revert to the state of the original motion
sequence. If you wish to keep the edited motion sequence,
you must perform the W rite operation ( p.47 ?Saving a pat-
tern?).
2While editing a motion sequence, it is not possible to use the
step keys to switch steps on/of f.
Depending on the part, some parameters cannot be selected.
Editing the parameter values of a
While recording a motion sequence, the display will indicate
?rEC,? and it will not be possible to edit a motion sequence.
motion sequence
While editing a motion sequence, the Rec key has no ef fect.
MOTION VALUE
PCh (PITCH/SPEED)dis, -64...63
5. Pattern mode
LEU (LEVEL)dis, 0...127
FLt (FILTER)dis, 0...127
Pan (PAN)dis, L.64...r.63
EFF (EFFECT)dis, oFF...on
roL (ROLL)dis, oFF...on
rEU (REVERSE)dis, oFF...on
Ed1 (EDIT 1)dis, 0...127
Ed2 (EDIT 2)dis, 0...127
dPt (DEPTH)dis, 0...127
tin (TIME)dis, 0...127
1. Use the cursor keys [2][1] to make the parameter select LED
indicate MOTION VALUE.
2. The display will alternately show the parameter name you se-
lected in the preceding OSelecting a motion sequence,� and the
45 |