PREPARING THE LAUNDRYSELECTING A DRYING TIME OR A FILTERAFTER-SALES SERVICE
PROGRAMME AND OPTIONS
1. Check that all fastenings are closed and that Clean the lint filter at the end of every If, after carrying out the above checks the
pockets are empty. Drying Time or programme and Options:drying cycle:malfunction persists or appears again, turn
2. Turn the articles inside out.? To select a drying time or a programme, turn 1. Open the door.the dryer off and call our After-Sales
3. Place laundry loosely in the drum to make the time selector knob clockwise.2. Pull the filter upwards.Service (refer to guarantee).
sure it doesn?t become tangled.? To select an option (if available), press the 3. Remove lint using a soft brush or your Please specify:
Sort laundry as follows:corresponding button. fingertips.? the nature of the fault.
4. Push the filter firmly back into place.
A) By care symbols ? Press the button again to cancel the option.? the dryer type and model.
(on the collar or inside seam):BUILT-IN INSTALLATION? the service code (the number after the word STARTING AND COMPLETING A
Service on the adhesive rating plate) on the DRYING CYCLE
Suitable for tumble dryingTo built in the dryerright hand side when door is open.
1. Having selected the desired drying time or a 1. It is recommended to not remove the
Tumble drying with reduced drying ? your full address and phone number.
programme and options, press the Start work-top.
intensity onlybutton.2. Connect the dryer to an external ventilation
Do not tumble dryIf the laundry is not removed at the end of system in order to prevent steam from
the drying cycle, an automatic anti-crease damaging your furniture during the years.
B) By amount and thickness/weightcycle will operate for max. 12 min. The
Whenever the load to be dried exceeds drum rotates at regular intervals preventing TROUBLESHOOTING GUIDE
dryer capacity, separate laundry according to the laundry from creasing.If a fault occurs, before contacting our
weight (e.g. towels from thin underwear).
2. On completion of the drying cycle, set the After-Sales Service, make the following
C) By type of fabricstime selector knob to position ?0?.checks to try and remedy the problem:
Cotton/linen: Towels, cotton jersey, bed The dryer indicator lamp ?On? goes off.
Drying takes too long / laundry is not dry
and table linen made of cotton or linen.
Synthetics/Easy Care: Blouses, shirts, INTERRUPTING A CYCLEenough:
? Was the correct drying time selected?
overalls, etc. made of polyester or To interrupt the dryer during operation
polyamide, as well as cotton/synthetic ? Was the inserted laundry too wet (Washing
mixes.1. Set the time selector knob to ?Airing?.machine spin speed less than 800 rpm)?
2. Wait at least 5 minutes before opening the
D) By drying level? Is the lint filter dirty (filter indicator lamp on)?
? Sort into: iron dry, cupboard dry, etc.door to allow the dryer to cool down.The dryer does not operate:
For your safety the drying time stops
Do not tumble dry: Woollens, silk, nylon ? Is the power plug properly inserted into the
stockings, delicate embroidery, fabrics with automatically if you open the door. mains electricity socket?
3. To restart, after door opening, close the
metallic decorations, bulky items such as sleeping door and press the start button again.? Is there a power failure?
bags, etc.
? Has the fuse blown?
Important: only use specific indicated dryer-? Is the door properly closed?
safe additives and rinse items that have been
? Has the drying time been selected?
treated with stain remover thoroughly in plenty ? Has the Start button been pressed?
of water before drying. Only use specific
indicated dryer-safe plastic items and never Lint filter indicator lamp on:
dry rubber or articles contaminated with ? Is the lint filter clean?
vegetable oil in the dryer.? Is the vent hose blocked?
5019 507 00507 |
ACEC
