Your TV receives signals from the video recorder (VCR) like another TV station.
You have to select a channel number on your TV and tune it in so that you may watch video
tapes.
in a
If you have used a SCART or AUDIO and VIDEO cables then your TV should already have
a dedicated video channel built into it, usually called AV.
Make sure that you haveInsert a pre-recordedTune this channel untilStore this channel on
TuningOn your TVcorrectly installed yourvideo tape into your VCRthe video picture is sharpyour TV.
VCR as described earlierand press PLAY on theand the sound is clear.
Video channelin this book.remote control.
Select a TV channel
Press POWER to turn onnumber on which you
The output frequency ofyour VCR.wish to watch videoOs.
this video recorder (VCR)
is set at UHF channel 22.Turn on your TV.DonOt worry if you donOt haveIf you have used a SCARTYou will need to look at the
a video-tape to play at thisor AUDIO and VIDEO cablesTV instruction book if you do
If channel 22 is already
stage!you will not have to tune yournot know how to do this.
used by another TV
If you switch your VCR onTV, simply select the AV
station, or if the picture is
and continue stages 3~4,channel. The AV channel is
distorted, you can
instead of seeing video already pre-tuned for opti-
change the transmitterplayback tune your TV untilmum video playback on your
channel of your VCR.you see a bright blueTV.
Stages 5~8 will show youscreen.
how to change the output
frequency of your VCR.
P/STILL
REWFF
PLAY
STOP
REC/
D
OK i
8 |
ACEC
