Welcome
Thank youSet up
for choosing a Loewe product.? Place the TV set on a rm, level base.
? Install the TV with enough room for ventila-
At Loewe we combine the highest standards tion. The vents may not be covered by any
of technology, design and user friendliness. objects. Keep a distance of at least 10 cm
away from adjacent objects.
This is equally true of TV, DVD, video, audio and
accessories..
Our design is not in uenced by short-term, 30 cm
fashionable trends. You have, after all, purchased 10
mcm
a high-quality piece of equipment which you do You should also read and follow the safety ad-
not want to get tired of looking at tomorrow or vice on the following pages.
the day after.
Please note!
Scope of delivery
The screen you have purchased meets the high-
? Plasma TV Loewe Concept L 42
est quality requirements and has been tested
? RC4 remote control with 2 batteries? Do not place the TV set in the vicinity of for pixel errors. Despite the utmost caution in
? Table-Stand (pre-assembled)sources of intense heat or in direct sunlight.
production of the sets, it cannot be totally ruled
? 2x spacers, self-adhesive? Do not place strong arti cial light sources in
? Power cord 2,5 mfront of the device. This may affect infrared out that some of the pixels might be defective
for technological reasons. Please understand
? VGA/DVI-adapter cablereception.
? RF connecting cable pre-assembled? If there is an electrical storm, disconnect the that such effects cannot be considered as a
? this operating manualantenna and mains plug. Power surges caused unit defect in the sense of the warranty as long
by lightning strikes can damage the unit as they are within the limits speci ed by the
Unpackingthrough the antenna system or the mains.standard.
? The antenna and mains should also be discon-
Place the box down vertical with the bottom nected if the unit is to remain unsupervised The light emission of plasma screens dimin-
on rm ground. The top is marked by arrows. for a long period of time.ishes with increasing use.
? The mains plug must be easily accessible so
Remove the adhesive tape carefully from the
box and remove the inside packing materials. that the unit can be disconnected at any time.Plasma screens operate on a phosphorus
? Lay the cable in such a way that it cannot
Remove the plasma screen from the packing basis. This technology can lead to burn-ins under
get damaged. The power cable should not
only with the assistance of a second person.be kinked or laid over sharp edges, not stood certain circumstances. Such operating conditions
If you have moved the TV set out of the cold upon or exposed to chemicals - the latter also may be:
into a warm environment, leave it standing for applies to the device as a whole. A mains ? prolonged display of a freeze frame (>10 Min)
about an hour because of the possible forming cable with damaged insulation can cause ? constantly displaying the same background
of condensation. Do not switch on until it has electric shocks and is a re hazard.? Use of a format which does not ll the screen
reached room temperature. This avoids seriously ? When removing the power plug, pull the body (e.g. 4:3) for a prolonged period.
damaging the componentsof the plug, and not the cable. Otherwise, These burn-ins cannot usually be removed once
the wires in the plug could get damaged they have occurred. To avoid or reduce burn-ins,
and cause a short circuit the next time it is please observe the following instructions and
plugged in.
recommendations:
? Do not place vases lled with water, lighted ? During the rst 100 hours of operation you
candles etc. on the top of the TV set.
should mainly show moving pictures or
frequently changing freeze frames which
cover the whole screen.
6
32241 Concept L42_Buch_GB.indd 614.10.2004 10:47:22 Uhr |
ACEC
