Connecting the A-9355/A-9155
Connecting Your Speakers
Speaker Connection PrecautionsConnecting the Speaker Cables
You can connect one or two sets of speakers (A/B) to
the A-9355/A-9155, and select which set outputs sound,
Strip about 15 mm (5/8 15 mm
1
or use both sets at the same time.(5/8")
inch) of insulation from
For both speakers A and B, make sure to connect them
the ends of the speaker
with Left and Right in pairs.
cables, and twist the bare
wires tightly, as shown.
Y If you connect both speaker sets to terminal A and B Unscrew the terminal.
2
respectively to deliver sound at the same time, only
connect speakers with an impedance of 8 ohms or
more but less than 16 ohms. If you use speakers with
a lower impedance, and use the A-9355/A-9155 at Fully insert the bare
3
high volume levels for a long period of time, the wires.
built-in protection circuit may be activated.
Y If you use speakers with an impedance of 4 to 8
ohms, connect them to either terminal A or B, or oth-
erwise do not use both speaker sets simultaneously to
Screw the terminal tight.
4
deliver sound.
Y Disconnect the power cord from the wall outlet
before making any connections.
Y Read the instructions supplied with your speakers.
YPay close attention to speaker wiring polarity. In other The following illustration shows which speaker should
words, connect positive (+) terminals only to positive be connected to each pair of terminals.
(+) terminals, and negative (�) terminals only to nega-
tive (�) terminals. If you get them the wrong way Right Speaker set ALeft
speakerspeaker
around, the sound will be out of phase and will sound
unnatural.
-+-+
Y Unnecessarily long or very thin speaker cables may
affect the sound quality and should be avoided.
Y Be careful not to short the
positive and negative wires.
Make sure also the wires do
not touch the rear panel.
Doing so may damage the
A-9355/A-9155.
Y DonOt connect more than one
cable to each speaker terminal. Doing so may damage
the A-9355/A-9155.
Y DonOt connect a speaker to more than one pair of The illustration repre-
sents the A-9355; how-
speaker terminals.
ever, it is also applicable
to the A-9155. So use
the same connection
procedures.
A-9355
-+-+
Right Speaker set BLeft
speakerspeaker
10 |
ACEC
