Troubleshooting
If you have any problems with the unit, please check the troubleshooting table below first.
For any problems not covered in the table, please consult your nearest Onkyo authorized service center.
SymptomCauseRemedy
STANDBY/ON button isY Power cord plug is not properly con- Y Insert the plug firmly.
pressed, but power does notnected to AC outlet.
come on.
Y The R-805TXOs energy save function Y Press the R-805TXOs STANDBY/ON but-
is enabled (when the R-805TX is con-ton. The power to the C-705TX will
nected).be turned on.
Disc is loaded in the disc tray,Y Disc is in the disc tray upside down.Y Load the disc with the label facing
but playback will not begin.upward.
Y Disc is dirty.Y Clean the disc.
Y Moisture has accumulated inside the Y Remove the disc from the disc tray, place
CD player.the CD player in a warm place and leave
the power on for about one hour.
Y You are playing an incorrectly-re- Y Replace the disc.
corded CD-R.
No soundY Incomplete or incorrect connections. Y Check all cable connections. (See
pages 10-12)
YInsert all plugs firmly into jacks.
Y Improper input selector switch setting Y Set switch to proper position. See your
on amplifier.amplifiers operating instructions for
more information.
Disc skippingY Disc is dirty.Y Clean the disc. (See page 19)
Y Disc is scratched.Y Replace the disc.
Y CD player has been bumped.Y Place the CD player in a more stable
location.
Search time (when moving toY Disc is dirty.Y Clean the disc. (See page 19)
a specific track) is extremely
long.Y Disc is scratched.Y Replace the disc.
Track numbers cannot beY No disc in the tray.Y Load a disc into the tray.
stored in the memory.
Y A track number not on the disc is Y Use only the track numbers on the
being input.disc.
Noise during playY Interference from TVY Turn off the TV, or move the unit far-
ther from the TV.
Remote controller does notY Battery level is low.Y Replace the batteries.
function.
Y Your position is too far from the unitOs Y Remote controller is possible within a
remote control sensor or out of thedistance of approximately 5 meters
sensorOs detection angle.from the unitOs sensor and a detection
range of 30!.
Y An obstacle exists between you and Y Operate from a different position or
the unitOs remote control sensor.remove the obstacle.
Y The system components are not con- Y Connect the system components
nected properly.properly according to the A-905TX/R-
805TX instruction manual.
20 |
ACEC
