Troubleshooting
If you have any trouble using your CR-505, check the following table for possible causes and remedies. If you still canOt
resolve the issue yourself, please contact your Onkyo dealer.
TroublePossible CauseRemedy
Connect the power cord properly to a suitable
CanOt turn on the CR-505? The power cord is not connected properly.
wall outlet (page 16).
Check the speaker connections and make sure
The speaker cables are not connected prop-that none of the wires are touching each other,
erly.other connectors, or any metal parts
(page 11).
The volume is set at minimum.Turn up the volume (page 19).
ThereOs no sound coming
The CR-505 is muted.Unmute the CR-505 (page 27).
from the speakers?
Turn down the volume, then disconnect the
A pair of headphones is connected.
headphones (page 19).
The wrong input source is selected.Check the input source setting (page 19).
Check your connecting cables for signs of
A connecting cable may be damaged.
damage and replace as necessary.
Check the speaker connections and make sure
Sound is coming from only The other speakerOs cable is not connected that none of the wires are touching each other,
one speaker?properly.other connectors, or any metal parts
(page 11).
The batteries are used.Replace with new batteries (page 7).
Check the batteries and correct as necessary
The batteries are installed incorrectly.
(page 7).
The remote controller YouOre not pointing the remote controller at Point the remote controller at the CR-505Os
doesnOt work?the CR-505Os remote sensor.remote sensor (page 7).
Make sure that the CR-505 is not subjected to
A strong light source is interfering with the
direct sunshine or inverter-type �uorescent
CR-505Os remote sensor.
lights. Relocate if necessary.
AM reception is hindered Relocate your AM antenna.
by a buzzing noise, espe-Interference caused by electrical equip-
cially at night or with weak ment, including �uorescent lights.Install an outdoor AM antenna (page 13).
signals?
Move the AM loop antenna as far away as
AM reception is hindered possible from your TV.
Interference caused by your TV.
by a high-pitched noise?Move the CR-505 as far away as possible
from your TV.
Install an outdoor antenna as far away as pos-
sible from nearby roads.
Interference is being caused by �uorescent
Reception is hindered by a Move your antenna as far away as possible
lights being turned on or off, or by the igni-
crackling noise?from �uorescent lights.
tion systems of passing cars.
Adjust the position or direction of your out-
door antenna.
FM reception and stereo Tall buildings, mountains, or hills are caus-
separation are poor even ing wave re�ections that interfere with the Try an FM antenna with better directionality.
though the Tuning and FM main signal.
STEREO indicators are
shown.The stationOs signal is too strong.Try an indoor FM antenna.
33 |
ACEC
