Before Using the DPS-5.4
Installing the BatteriesUsing the Remote Controller
To use the remote controller, point it at the DPS-5.4Os
Open the battery compartment, as shown.remote control sensor, as shown below.
1
Remote control sensor
DPS-5.4
Standby/On
PStaondwebyrOnO f fDisplayPlay ModeDimmerClear
Open /ClosePauseStop
Play
DPS-5.4
Insert the two supplied batteries (AA) in 30u
2
30u
accordance with the polarity diagram
inside the battery compartment.
Approx. 16 ft. (5 m)
Notes:
Y The remote controller may not work reliably if the
DPS-5.4 is subjected to bright light, such as direct
sunlight or inverter-type Ãï¿œuorescent lights. Keep this
Close the battery compartment.
3in mind when installing the DPS-5.4.
Y If another remote controller of the same type is used in
the same room, or the DPS-5.4 is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
Y DonOt put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
Y The remote controller may not work reliably if the
DPS-5.4 is installed in a rack behind colored glass
Notes:
doors. Keep this in mind when installing the DPS-5.4.
Y The supplied batteries should last for about six
Y The remote controller will not work if thereOs an obsta-
months, although this will vary with usage.
cle between it and the DPS-5.4Os remote control sen-
Y If the remote controller doesnOt work reliably, try
sor.
replacing both batteries.
Y DonOt mix new and old batteries, or different types of
batteries.
Y If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage
and corrosion.
Y Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.
11 |