Index to Parts and Controls
Rear panel
12 34 5678
LSURROUND
PREOUTANTENNASPEAKERSIRRLRCENTERLAC INLETFRONT SPEAKERS
AUDIO
REMOTEINANTENNA
CONTROLR
AMFM 75
SUBINOUTIN
WOOFER TV/LINEMD/CDR/TAPE
DIGITALVIDEO OUTPUT
OPTICALYPBPR
OUTINS VIDEOVIDEOCOMPONENT
90
Shapes of jacks vary depending on the area in which it was6 ANTENNA terminals [22, 23]
purchased.These terminals are for connecting the FM antenna and AM
antenna.
1 SUB WOOFER PRE OUT jack [17, 18]
This terminal is for connecting an active subwoofer.7 FRONT SPEAKERS, CENTER SPEAKER and SURROUND
SPEAKERS terminals [18]
2 TV/LINE IN jacks [16,19]Speaker terminals are provided for the front left, front right, center,
This terminal is for connecting audio output terminals of TV, VCR orsurround left and surround right speakers.
other video equipment.
8 AC INLET [24]
3 MD/CDR/TAPE IN/OUT jacks [19]Connect supplied AC power cord to this terminal.
These terminals are for connecting to the recording input and
output terminals of an MD recorder, CD recorder or tape deck.
9 DIGITAL OPTICAL IN/OUT jacks [16, 19]
These are the digital audio input and output jacks. The digital input
4 z REMOTE CONTROL connector [20]works in combination with the analog TV/LINE IN jacks. Connect
Connect the Integra/Onkyo components that have z connectorsthe digital output from your TV or satellite tuner (MD player, etc.) to
such as a MD recorder, and cassette tape deck using the zDIGITAL OPTICAL IN. Set the Input Selector to TV/LINE IN to play
cables provided with them. When these components arethe digital sound. Connect the DIGITAL OPTICAL OUT to a digital
interconnected, they can be controlled from the remote controllerrecording device (MD recorder, CD recorder, etc.). Do not connect
provided with the DVD Receiver.the DIGITAL OPTICAL OUT if the digital output from the same
After connecting the z connectors, check the operation of thecomponent is connected to the DIGITAL OPTICAL IN.
remote controller buttons for use in controlling other components.
0 VIDEO OUTPUT (VIDEO/S VIDEO/COMPONENT) jacks
5 IR IN jack [21][16]
If the DSR-7.3 is located inside a rack or cabinet that will not allowThe monitor output includes RCA type, S video and component
infrared beams to reach the IR sensor, you will need to connect aconfigurations. This output is for connecting television monitor or
remote sensor to IR IN jack to be able to use the remote controller.projector.
Then install the remote sensor in an unblocked location where you
can easily point the remote controller.
14 |
ACEC
