Precautions
DANGER:Y Reorient or relocate the receiving antenna.
INVISIBLE LASER RADIATION WHEN OPEN AND INTER-Y Increase the separation between the equipment and receiver.
Y Connect the equipment into an outlet on a circuit different from that
LOCK FAILED OR DEFEATED. AVOID DIRECT EXPOSUREto which the receiver is connected.
TO BEAM.
Y Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
For Canadian model
THIS PRODUCT UTILIZES A LASER. USE OF CONTROLSCAUTION: THIS DIGITAL APPARATUS DOES NOT EXCEED THE
OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT INCLASS B LIMITS FOR RADIO NOISE EMISSION FROM DIGITAL
APPARATUS SET OUT IN THE RADIO INTERFERENCE REGULA-
HAZARDOUS RADIATION EXPOSURE.
TIONS OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS.
For European model
This unit contains a semiconductor laser system and is classified as aFor models having a power cord with a polarized plug:
OCLASS 1 LASER PRODUCT.� So, to use this model properlyCAUTION: , readTO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE
this Instruction Manual carefully. In case of any trouble, please contactOF PLUG TO WIDE SLOT, FULLY INSERT.
the store where you purchased the unit. To prevent being exposed to
the laser beam, do not try to open the enclosure.Modele pour les Canadien
ATTENTION: LOINTERFERENCE RADIO ELECTRIQUE GENEREE
PAR CET APPAREIL NUMERIQUE DE TYPE B NE DEPASSE PAS
LES LIMITES ENONCEES DANS LE REGLEMENT SUR LES PER-
OCLASS 1 LASERTURBATIONS RADIO ELECTRIQUES, SECTION APPAREIL
PRODUCT�NUMERIQUE, DU MINISTERE DES COMMUNICATIONS.
Sur les modeles dont la fiche est polarisee:
This label on the rear panel states that:ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES,
1. This unit is a CLASS 1 LASER PRODUCT and employs a laserINTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA
BORNE CORRESPONDANTE DE LA PRISE ET POUSSER
inside the cabinet.JUSQUOAU FOND.
2. To prevent the laser from being exposed, do not remove the cover.
Refer servicing to qualified personnel.
For U.S. model
The laser is covered by a housing which prevents exposure during
operation or maintenance. However, this product is classified as a Laser
Product by CDRH (Center for Devices and Radiological Health) which
is a department of the Food and Drug Administration.
According to their regulations 21 CFR section 1002.30, all manufactures
who sell Laser Products must maintain records of written
communications between the manufacturer, dealers and customers
concerning radiation safety. If you have any complaints about
instructions or explanations affecting the use of this product, please
feel free to write to the address on the back page of this manual. When
you write us, please include the model number and serial number of
your unit.
In compliance with Federal Regulations, the certification, identification
and the period of manufacture are indicated on the rear panel.
FCC INFORMATION FOR USER
CAUTION:
The user changes or modifications not expressly approved by the party
responsible for compliance could void the userOs authority to operate
the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
3 |
ACEC
