Precautions
CAUTION:For Canadian model
VISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKFor models having a power cord with a polarized plug:
FAILED OR DEFEATED. DO NOT STARE INTO BEAM.CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
CAUTION:NOTE: THIS CLASS B DIGITAL APPARATUS COMPLIES
THIS PRODUCT UTILIZES A LASER. USE OF CONTROLSWITH CANADIAN ICES-003.
OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT INModele pour les Canadien
Sur les modeles dont la fiche est polarisee:
HAZARDOUS RADIATION EXPOSURE.
ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES,
For U.S. modelINTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS
The laser is covered by a housing which prevents exposure duringLA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER
operation or maintenance. However, this product is classified as aJUSQUOAU FOND.
Laser Product by CDRH (Center for Devices and Radiological Health)
REMARQUE: CET APPAREIL NUM?RRIQUE DE LA CLASSE
which is a department of the Food and Drug Administration.B EST CONFORME � LA NORME NMB-003 DU CANADA.
According to their regulations 21 CFR section 1002.30, all
manufactures who sell Laser Products must maintain records of written
communications between the manufacturer, dealers and customers
concerning radiation safety. If you have any complaints about
instructions or explanations affecting the use of this product, please
feel free to write to the address on the back page of this manual.
When you write us, please include the model number and serial
number of your unit.
In compliance with Federal Regulations, the certification,
identification and the period of manufacture are indicated on the rear
panel.
FCC INFORMATION FOR USER
CAUTION:
The user changes or modifications not expressly approved by the
party responsible for compliance could void the userOs authority to
operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Y Reorient or relocate the receiving antenna.
Y Increase the separation between the equipment and receiver.
Y Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Y Consult the dealer or an experienced radio/TV technician for help.
3 |
ACEC
