Turning on
Connecting the POWER
Notes
The DV-SP300 is shipped with the main power (POWER) switch in the
on position ( ON). When the power cord is plugged in for the firstY Make sure that all appropriate connections have been completed as
time, the DV-SP300 will automatically enter the standby mode and thedescribed on pages 14 to 16.
STANDBY indicator will light (same condition after step 2 below).Y Turning on the DVD Player may cause a momentary power surge,
which might interfere with other electrical equipment such as
computers. To prevent interference, use a wall outlet on a different
POWERSTANDBY/ONcircuit.
STANDBY indicator
1Plug the power cord into the
power outlet on the wall.
STANDBY/ON
2Press POWER to switch on
the main power.
The DVD Player enters standby mode.
The STANDBY indicator lights up.
Notes
Y The buttons on the remote controller do not operate if the POWER
switch is set to OFF.
Y To switch off the main power, press POWER again.
3Press STANDBY/ON on
the DVD Player or remote
controller.
The DVD Player turns on and the STANDBY indicator
turns off. It takes several seconds to read the disc in the disc
tray.
Notes
Y You can turn on the DVD Player by pressing 0 or L/8.
Y To put the DVD Player in the standby mode, press
STANDBY/ON on the DVD Player, or remote controller. Be
sure to set the volume to minimum before putting the DVD
Player in the standby mode for the next use to avoid sudden loud
sound reproduction.
Y While the STANDBY indicator lights up, the DVD Player can
receive signals from the remote controller. However, if you press
POWER on the DVD Player to switch off the main power, the
remote controller cannot be used to turn on the DVD Player.
Y Setting the STANDBY button to standby does not shut off the
power completely.
17 |
ACEC
