Connecting the Power/Turning on the DVD Player
Before connecting
Y The DV-SP800 is shipped with the main power (POWER)
switch in the on position (_ ON). When the power cord is
plugged in for the first time, the DV-SP800 will automatically
enter the standby state and the STANDBY indicator will
light (same condition after step 2 below).
Y Make sure that all the connections on pages 15-19 are complete
(the connection to a TV is required).
Plug the supplied power cord into Setting the TV System (Other than US and
1Canada models)
the AC INLET and then into the
power outlet on the wall.The default setting of this player is AUTO, and unless you notice that
Y Do not use a power cord other than thethe picture is distorted when playing some discs, you should leave it
set to AUTO.
one supplied with the DV-SP800. The
power cord supplied is designed for useIf you experience picture distortion with some discs, set the TV
system to match your country or regionOs system. Doing this,
with the DV-SP800 and should not be
used with any other device.however, may restrict the kinds of disc you can watch. The table
below shows what kinds of disc are compatible with each setting
Y Never have the power cord(AUTO, PAL and NTSC).
disconnected from the DV-SP800 whileDiscOutput format
the other end is plugged into the wall
TypeFormatPosition of TV SYSTEM mode
outlet. Doing so may cause an electric
shock. Always connect by plugging intoNTSCPALAUTO
the wall outlet last and disconnect byDVDNTSCNTSCMOD. PALNTSC
unplugging from the wall outlet first.
PALPALPAL
AC INLETVideo CDNTSCNTSCMOD. PALNTSC
PALNTSCPALPAL
CD, No discNTSCPALNTSC or PAL
1 Switch the player into standby.
To the mains2 Hold down c then press STANDBY/ON until the display
indicates the new setting to switch the TV system.
Press POWER to switch on the mainThe TV system changes as follows:
2
power.AUTO =NTSC
NTSC =PAL
The DVD Player enters standby mode.
PAL =AUTO
The STANDBY indicator lights up.Note that you have to switch the player into standby before each
Y The buttons on the remote controller dochange.
not operate if the POWER switch is set
About MOD. (Modulation) PAL
to OFF.Y SHRINK
Y To switch off the main power, pressMost models of the newly developed countdown PAL TV system
POWER again.detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch
vertical amplitude, resulting in a display without vertical
shrinkage.
Press STANDBY/ON on the DVDY If your PAL TV does not have a V-Hold control, you may not be
3Player or ON on the remoteable to view NTSC disc because the picture may roll. If the TV
controller.has a V-Hold control, adjust it until the picture stops rolling. On
some TVs, the picture may shrink vertically, leaving black bands
The DVD Player turns on and the STANDBY
indicator turns off.at the top and bottom of the screen. This is not a malfunction; it is
caused by the NTSC = PAL conversion.
Y To put the DVD Player in the standby
mode, press STANDBY/ON on the DVD
Player, or STANDBY on the remote
controller. Be sure to set the volume to
minimum before putting the DVD Player
in the standby mode for the next use to
avoid sudden loud sound reproduction.
Y While the STANDBY indicator lights up,
the DVD Player can receive signals from
the remote controller. However, if you
press POWER on the DVD Player to
switch off the main power, the remote
controller cannot be used to turn on the
DVD Player.
Y Setting the STANDBY button to standby
does not shut off the power completely.
20 |
ACEC
