Troubleshooting
If you have any trouble using the DX-7355, look for a solution in this section.
If you can?t resolve the issue yourself, try resetting the DX-7355 before contacting your Onkyo dealer.
To reset the DX-7355 to its factory defaults, turn it on and, while holding down the
[] button, press the [REPEAT] button. CLEAR will appear on the display.
Note that resetting the DX-7355 will delete your custom settings.
Power
Cant turn on the DX-7355.
? Make sure that the power cord is properly plugged into the wall outlet (page 15).
? Unplug the power cord from the wall outlet, wait five seconds or more, then plug it in again.
Audio
Theres no sound.
? The DX-7355 is not connected properly. Check all connections and correct as necessary.
? The wrong input source is selected on your amplifier. Check your amplifiers input source setting. Refer to your
amplifiers manual.
CD
Cant play a CD.
? The disc is upside down. Load the disc with the label-side facing up (page 16).
? The disc is dirty. Remove the disc and clean it (page 11).
? Condensation has formed inside the DX-7355. Remove the disc and leave the DX-7355 turned on for several hours
until the condensation has evaporated.
? The disc is nonstandard. See Supported Discs on page 11.
? The CD-R/RW disc is nonstandard. See Supported Discs on page 11.
CD playback skips.
? Install the DX-7355 somewhere free of vibration.
? The disc is dirty. Remove the disc and clean it (page 12).
? The disc is very scratched. Replace the disc.
Cant enter track numbers for memory playback.
? No such track on the CD. Enter another number (page 22).
It takes a long time to locate certain tracks.
? The disc is dirty. Remove the disc and clean it (page 12).
? The disc is very scratched. Replace the disc.
SETUP
Cant find a SETUP menu in need.
? If any track has been selected even when the DX-7355 is stopped, you must place it into the full stop state by pressing
the [ ] button before you can view all the SETUP menus.
Remote Controller
The remote controller does not work.
? There are no batteries in the remote controller. Install new batteries (page 10).
? The batteries are flat. Replace with new batteries (page 10).
? The batteries are installed incorrectly. Check the batteries and correct as necessary (page 10).
? Youre not pointing the remote controller at the DX-7355s remote sensor. Point the remote controller at the
DX-7355?s remote sensor (page 10).
? Youre too far away from the DX-7355. Use the remote controller closer to the DX-7355 (page 10). The remote
controller has a range of approximately 5 meters (16 ft.).
? A strong light source is interfering with the DX-7355s remote sensor. Make sure that the DX-7355 is not subjected
to direct sunshine or inverter-type fluorescent lights. Relocate if necessary.
? If the DX-7355 is installed in a cabinet with colored glass doors, the remote controller may not work reliably when
the doors are closed. Open the doors, or use a cabinet without colored glass.
26 |
ACEC
