Synchronous recording
3Press the o REC button.
DX-R700RC-448C
RECREC
ORec Setup� appears in the display followed by
the time display (the recording standby state).
Proceed to step 6 if you do not wish to adjust
the recording level.
4Adjust the recording level.
Refer to page 21, step 4 OAdjust the recording
level.�
5Stop the playback of the source device.
6Press the play button on the source
device to start the playback.
Playing starts and recording starts at the DX-
R700.
When the playback finishes
Only when you perform the digital synchronous
recording from the CD player, the DX-R700 will go
into the recording standby state. After the recording
standby state lasts 10 minutes, the DX-R700 will
stop automatically.
In any other recordings, you will have to stop the
recording manually using the e STOP button on the
DX-R700.
To stop the synchronous recording
Press the e STOP button on the DX-R700. When
you are performing the digital synchronous
recording from the CD player, the stop of the CD
playback will cause the DX-R700 to enter the
recording standby state.
While performing analog recording, do not switch
the input selector control on the amplifier.
25 |