3 Select a program number on the TV whichIf Auto Tuning stops halfway by turning the
you wish to use as the video viewingVCR off, playback or a power failure:
channel. Then tune in the TV to the picture1 Disconnect the mains lead and then
from the screen being auto tuned or thereconnect it.
screen selected with the I and J buttons
of the VCR.2 Turn off the VCR and then turn it on.
-During Auto Tuning, the TV program- Auto Tuning commences.
screen does not appear, and the Auto
Tuning screen appears instead.
To Change the RF Output
2Channel
AUTO CHANNEL SETAUTO TUNING IS
COMPLETED.
PROCEEDINGIn some rare cases after tuning the TV to your
END: MENUEND: MENUVCR, interference may be visible on the
picture. To get rid of this interference, you canSetting Up
manually adjust the RF output channel a few
To Cancel Auto Tuning Mid-channels up and down from the current setting.
The procedure is described below.
Operation
Press [MENU] during Auto Tuning. Auto Tuning
1 Hold down [MENU] for 5 seconds or more.
is cancelled.
- The VCR display changes as shown below
and the VCR picture on the TV displays
To Restart Plug in Auto Tuningthis pattern.
1 Press [EJECT] and remove the video
cassette.
Panasonic VCR
2 Keep the I and J buttons on the VCR
pressed simultaneously for 3 seconds orEND: MENU
more during the VCR on.
-The channel displayed on the VCR display
disappears for a moment then changes to2 Enter the desired channel number (US3 or
2.US4) by the I and J buttons.
3()4
3 Press [MENU] to finish the setting mode.
Disappears 2
4 Retune your TV to the new RF channel for
3 Disconnect the mains lead and then
the VCR.
reconnect it.
Note:
4 Turn off the VCR and then turn it on.
- Even if the RF output channel has been
Press [VCR/TV] to select the VCR mode.
changed, it is not necessary to perform Auto
-Auto Tuning commences.
Tuning.
13 |