Preparation
Setting the camera IDSetting the date and time
The camera ID is set on the <CAMERA ID> screen. Up to 12
Proceed with the sub-menu operation
alphanumerics, symbols and spaces can be used.1
(page 37) to open the <TIME/DATE> screen.
<Note>
The camera ID does not appear while the setting menu is displayed
#3< TIME/DATE >
even when color bar signals are output.
YEAR :01
MONTH :01
Proceed with the sub-menu operationDAY :01
1HOUR :00
(page 30), and open the <CAMERA ID>MINUTE :00
screen.
TIME/DATE SET:READY
#3< CAMERA ID >
CAMERA ID:ID
ID:cccccccccccc
Turn the JOG dial button to select the item
2
Turn the JOG dial button to move the
2to be changed, and press the JOG dial
arrow (cursor) to the ID item.button.
3< CAMERA ID >3< TIME/DATE >
CAMERA ID:IDYEAR :01
vMONTH :01
# ID:ccccccccccccDAY :01
HOUR :00
# MINUTE :00
When the JOG dial button is pressed, theTIME/DATE SET:READY
3
arrow (cursor) flashes to signal that the
input mode has been established.
Keep turning the JOG dial button until Ttheurn the JOG dial button to change the
43
character to be set appears.setting, and then press the button to enter it.
When the button is turned, the character display is switched in
the following sequence:
When the setting is completed, turn the
Space:4
JOG dial button to select TIME/DATE SET,
7
Letters of the alphabet:A through Zand press the button.
7
The READY display changes from ACTIVE to OK, and the
Numbers:0 through 9clock function starts operating.
7
Symbols:', >, <, /, -3< TIME/DATE >
YEAR :01
MONTH :01
Press the JOG dial button to enter theDAY :01
5HOUR :00
character.
MINUTE :00
# TIME/DATE SET:OK
Turn the JOG dial button to move the
6
arrow (cursor) to the next position (on the
right), and repeat steps 3, 4 and 5 to enter
the remaining characters.
Press the MENU button to end the menu
5
operation.
Press the MENU button to end the menu
7
The setting menu is cleared, and the units current status is
operation.
displayed.
The setting menu is cleared, and the units current status is
displayed.
<Note>
To change the ; back to >, press the JOG dial button when
eThe seconds cannot be set. The time always starts from zero
the ; is above the colon (:).
seconds.
<Note>eAt normal temperature with the power off, the clock will have an
The camera ID input above will be recorded at the same accuracy time as theof ?30 seconds/month. When accurate time is
necessary, check the time with the power on and reset to the
color bar signals.
correct time.
14 |