Checking the system operations (continued)
Check what you have shot (rec check)Eject the tape
1Press the OPEN button in the direction shown 1Slide the EJECT switch in the direction shown
by arrow (1) to open the LCD.by the arrow to open the cassette cover.
It can open out to 120 degrees. Do not try to When the cassette cover is fully open, the
open it further as this will damage the camera.cassette holder automatically opens out.
? The cassette holder will not open if the
camera is not supplied with power (AC
adapter or battery).
120Lock release
2Remove the cassette.
2While in the shooting standby mode, press the Press PUSH to close the cassette holder.
REC CHECK button.
A few seconds of the last thing you shot play,
and then the camera returns to the shooting PUSH
standby mode.
REC CHECK button
PUSH
3Close the cassette cover only after the cassette
holder is completely in position.
Do not close the cassette cover while the
cassette holder is moving as this can damage
Power saving mode
the mechanism.The camera-recorder performs as follows when you
pause or leave it in standby mode for about 5
minutes, and do not perform any specified ? Make sure the camera-recorder is supplied with
operations. power before operating the EJECT switch.
ON: The camera recorder turns off automatically? Close the cassette holder again if you are not
OFF: The cylinder head pauses and goes into going to insert another tape.
? Do not open the cassette cover while you are
standby mode without cutting the power.recording.
See the setup menus, OTHER FUNCTIONS Recording continues, and the open cover allows
screen, POWER SAVE (Page 78) for details.outside light and dust to adversely affect the tape.
12 |
ACEC
